Can Bulldog Rack and Gear Jack be Mounted so the Handle is More to the Front of the Trailer
Question:
I have a tongue mounted box that is sandwiched between the front wall of my RV and the existing A-frame jack. The A-frame jack that I want to replace is front winding. Will this Bulldog jack mount 120 degrees out, so that it is no longer side winding but nearly front-winding?
asked by: Steve
Expert Reply:
Technically, yes, you can position and bolt down Bulldog rack and gear jack # BD018155 with # BD018006 so that the handle winds at the front of the trailer instead of to the side but it may not be the best fit.
For what you want to do I recommend the Fulton F2 jack # F1413250334 which has more mounting options and a round bracket for a better fit.
To this jack you can add a single wheel # F500266 if you wish.
Products Referenced in This Question
Replacement Rack-and-Post Assembly w/ Steel Wheel for Bulldog Rack-and-Gear Jacks - 21"
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Jack Assembly
- Bulldog
more information >
Fulton F2 Adjustable A-Frame Jack - Sidewind - 9" Lift - 2,000 lbs
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- Leveling Jacks
- Tongue Jacks
- Steel
- 1001 - 2000 lbs
- Sidewind Jack
- 9 Inch Lift
- Bolt-On
- No Wheel or Foot
- Fulton
more information >
Wide-Track Wheel Assembly for Fulton F2 Adjustable A-Frame Jack - 8" Diameter - 1,600 lbs
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Jack Wheel
- 8 Inch Wheel
- Wheel w Caster Assembly
- Fulton
more information >
