2013 Ford Escape Shows Bulb Out when Trailer with LED Lights is Connected
Question:
I have a 2013 ford escape. When I plug in trailer with led lights on the trail. I turn the turn signals and on the dash it says there is a bulb out. What should I do to correct this problem ?
asked by: Don S
Expert Reply:
The bulb out error or hyper flashing can occur any time LED lights are used in place of incandescent lights. Usually this issue is found on vehicles but has been know to occur on trailers as well. You will need to make the tow package wiring on the vehicle think there is more draw from the lights. To do this I recommend using load resistors on the affected circuits.
If the trailer lights use the 3-prong plug like # ST70RB you can use # ALEDRST1B. Or you could install resistors such as # DI34ZR along the wiring to the lights. The increased load from the resistors will take care of the problem. I have linked a video showing an example installation of a load resistor.
Products Referenced in This Question
Optronics Load Resistor for LED Lights - Male PL-3 Plug and Pigtail - Qty 1
- Accessories and Parts
- Trailer Lights
- Load-Resistor Kit
- Aluminum
- Optronics
more information >
Load Resistor Kit for LED Turn Signals - 50 Watts - 6 Ohm - Qty 2
- Accessories and Parts
- Trailer Lights
- Load-Resistor Kit
- Diamond
more information >
Product Page this Question was Asked From
Optronics Trailer Tail Light - Stop, Turn, Tail - Submersible - Incandescent - Oval - Red Lens
- Trailer Lights
- Tail Lights
- Stop/Turn/Tail
- Oval
- Recessed Mount
- Submersible Lights
- Incandescent Light
- 6-1/2L x 2-1/4W Inch
- Red
- Optronics
more information >
Continue Researching
- Shop: Optronics Fleet LED Trailer Tail Lights w/ Grommets - Stop,Turn,Tail - Submersible - Oval - Qty 2
- Video: Review of Peterson Trailer Lights - Liscense Plate Lights - M400
- Video: Review of Diamond Lights - Load Resistors - DI34ZR
- Video: Review of Optronics Trailer Lights - License Plate Lights - OPT77FR
- Video: Optronics Lights ALEDRST1B Review
- Search Results: load resistors
- Search Results: heat shrink butt connector
- Search Results: 2 wire pigtail
- Search Results: license plate lights
- Shop: Deka Heat Shrink Butt Connector - 12-10 Gauge - Nylon Insulation - Yellow - Qty 5
- Shop: Hopkins 2-Pole Flat Wiring Extension - 12" Long
- Shop: Optronics Load Resistor for LED Lights - Male PL-3 Plug and Pigtail - Qty 1
- Shop: Mini LED Trailer License Plate Light - 2 Diodes - Clear Lens - 12V/24V
- Shop: Optronics Load Resistor for LED Lights - Male PL-3 Plug and Female PL-3 Plug - Qty 1
- Shop: Load Resistor Kit for LED Turn Signals - 50 Watts - 6 Ohm - Qty 2
- Q&A: Power Issues When Installing LED Lights to Replace Incandescents
- Shop: Truck Tailgate Lock
- Search Results: 3 wire pigtail
- Search Results: pl~3
- Video: Command Electronics Trailer Lights - Tail Lights - 328-003-6016 Review
- Video: Review of Optronics Trailer Lights - Tail Lights - OPT24NR
- Video: Review of Optronics Trailer Lights - Submersible 3 Function Red LED Trailer Tail Light - OPT54WR
- Shop: Trailer Hitch
- Article: Trailer Wiring Diagrams
- Q&A: Wiring a Camper Shell Third Brake Light on a 2017 Chevrolet Silverado
- Search Results: 44649
- Shop: Trailer Wiring
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Replacement LED Top Command Clearance Light With SAE-AP2-16 On Lens For 2018 Sunseeker Motorhome
- Shop: Brake Controller