Brake Controller and Installation Recommendation for a 2008 Chevy Silverado 2500
Question:
once 2008 chevrolet 2500 wires under hood hooked for trailer brakes the trailer brakes controlled by truck pedal brake ?
asked by: Gar T
Expert Reply:
Once you make all of the under hood connections on your 2008 Chevy Silverado to activate the trailer brake controller circuit you will be able to install a brake controller to activate the trailer's brakes, but they would not be directly controlled by the brake pedal.
For a brake controller I would recommend the Prodigy P2 Brake Controller part # 90885. This is our best selling brake controller because of how well it works and how easy it is to setup. This is a proportional brake controller that senses the amount of braking the tow vehicle is applying and applies a proportionate amount to the trailer brakes.
I attached an install video that shows this controller being installed in a 2008 Chevy Silverado for you to check out as well.
Products Referenced in This Question
Tekonsha Prodigy P2 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Electric over Hydraulic
- Automatic Leveling
- Under-Dash Box
- Dash Mount
- Up to 4 Axles
- LED Display
- Up to 360 Degrees
- Tekonsha
more information >
Product Page this Question was Asked From
Twist-in, 7-Pole, RV-Style Trailer Connector for Chevy and GMC Vehicles - Vehicle End
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- No Converter
- Custom Fit
- 7 Round - Blade
- Pollak
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: How to Choose the Right Trailer Hitch Class
- Article: Most Popular Wheel Bearings
- Q&A: Difference Between Curt 15312 and 15313 for 2005 GMC Sierra 2500
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Q&A: How Tight Should Castle Nut be on Trailer Hub
- Q&A: Proper Way to Tighten Trailer Spindle of Castle Nut
- Q&A: How to Determine Compatible Replacement Trailer Hubs
- Article: Trailer Wiring Diagrams
- Article: Installing an Electric Brake Controller on 2007-2013 GM Full-Size Truck or 2007-Present GM SUV
- Article: Brake Controller Installation for 2007 (New Body Style) - 2013 GMC Sierra and Chevy Silverado
- Q&A: Removing the 7-Way Trailer Wiring Plug from the Housing, 2010 Chevy Silverado with Factory 7-Way
- Article: How to Clean Weld Nuts for the Installation of a Trailer Hitch | etrailer.com
- Q&A: What Wires Does a Brake Controller Wire to on a 2009 Hummer H3
- Q&A: Do Trailer Hitches Fit Multiple Years Of The Chevy Silverado