XL Kodiak ProLube 1980 Castle Nut Washer Recommendation
Question:
I am trying to change my existing hubs, with the bearing numbers mentioned, to this kit. My problem is that the washer under the castle nut is bigger than the opening in the aluminum cap. Have checked and made sure all races are set correctly. Seal is drove in as far as possible. Any recommendations would be helpful.
asked by: Joe S
0
Expert Reply:
Do you have an overly large castle nut washer? It seems odd that the washer is too big to fit in the cap of the # XLPROLUBE1980KIT. Since this kit is designed for 3.5k axles the correct replacement washer should be the # 5-23. This washer should be very similar in size to the castle nut.
expert reply by:
Jameson C
0
Products Referenced in This Question
Product Page this Question was Asked From
Kodiak XL ProLube Kit for 3500-lb Axles
- Trailer Bearings Races Seals Caps
- Caps
- Oil Cap
- 1.98 Inch
- Kodiak
more information >
Continue Researching
- Q&A: Seal With Dimensions to Replace 171255UC
- Article: Parts Needed to Add Hydraulic Disc Brakes to a Trailer
- Article: Trailer Wiring Diagrams
- Q&A: Can Trailer Tire Size 175/80-13 Replace Size 185/80R13
- Q&A: Grease to Oil Bath Trailer Hub Conversion Kit for 3500 Pound Axles
- Q&A: Will The Kodiak Disc Brakes Kit # KOD49FR Fit In EZ Loader Trailer With 3,700LB Axle?
- Q&A: Bearing Kits For Lippert 3,500LB Trailer Axles
- Q&A: Replacement Grease Seal for a 168255TC Rubber Coated Seal
- Q&A: Is an Oil Bath System Compatible with EZ Lube Spindle # TRU74FR
- Article: Ram Trailer Tow Prep Package
- Article: Most Popular Wheel Bearings
- Article: Overview of Lubricating Grease
- Article: What To Look For When Buying Ratchet Straps
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub