Are Spacer Blocks Required for the Install of the Curt Hitch C13135 on a 2015 Subaru XV Crosstrek
Question:
i just finisched to install the c 13135 but when i tryed to install the spacers to level the unitlike it shoes in the instruction the bolts are to short.so i installed it w out spacers any problem w that???
asked by: Vincenzo T
0
Expert Reply:
The install instructions for the Curt hitch part # C13135 say to use the spacer blocks to level the hitch "as necessary". If the hitch sits level without the blocks then there's no reason you would have to put them in.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class III
- 525 lbs TW
- 3500 lbs GTW
- 2 Inch Hitch
- Visible Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Trailer Wiring
- Q&A: Why Are Spacer Blocks Needed to Install Trailer Hitch on 2003 Ford F-150
- Shop: Hopkins Plug-In Simple Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: How Can I Use My 2 Inch Bike Rack with my 1-1/4 Inch Hitch
- Q&A: Can A Class II Hitch be used with an Adapter to Transport a 477 Pound Motorcycle
- Q&A: Replacement Hitch Mounting Hardware for Curt 13135 Trailer Hitch
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: How To Wire Dometic RV Water Heater in Place of Atwood GC6AA-9E
- Article: Steel vs. Aluminum Ball Mounts
- Q&A: Difference Between Curt and etrailer Trailer Hitch Receivers for 2020 Chevy Colorado
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Hitch Installation Tips
- Article: What Do I Need To Tow A Trailer?
- Article: My Trailer Hitch Doesn't Fit
- Article: How to Measure for Trailer Hitch Drop