Distance from Weld to First Pin Hole on Advantage SportsRack Hitch Extender # HE6000
Question:
What is the distance from the weld on the back of the 2 inch receiver section to the center of the closest pin hole on the shank? In other words, how far back must the pin hole be on my hitch to use the closest pin hole on the shank of this extender?
asked by: Phil N
0
Expert Reply:
I went and grabbed an Advantage SportsRack Hitch Extender # HE6000 from our warehouse to get the dimension you are looking for. The distance from the weld to the nearest pin hole is 3-1/4 inches on the shank.
expert reply by:
Jameson C
0
click to enlarge
Product Page this Question was Asked From
Advantage SportsRack Hitch Extender for 2" Trailer Hitches - 11" Long
- Hitch Adapters
- Hitch Extender
- Bike Racks
- Cargo Carriers
- Hitch Mounted Accessories
- Trailers
- 11 Inch Extension
- Fits 2 Inch Hitch
- Heininger Holdings
more information >
Continue Researching
- Q&A: Is Spacing Around BullRing Tie-Downs in Stake Pocket Okay for a 2015 Ford F-350
- Q&A: Recommended Trailer Hitch for a 2023 Toyota RAV4
- Q&A: Titan Hitch Box Extension RP45292 Fits into a Hitch with a 2-1/2 Opening
- Q&A: Can Hitch Box Extension and Reducer Handle 5,300 Pound Trailer
- Article: 5 Things to Know About Weight Distribution Hitches
- Q&A: Wiring An Atwood RV Water Heater With Double-Panel On/Off Switch
- Article: Hitch Adapters and Extenders
- Q&A: Difference Between Brophy # BM20 and # BH20 Ball Mounts
- Q&A: Compatibiility of Hollywood Racks RV Rider Bike Rack Behind a 2022 Jeep Wrangler With Spare Tire
- Article: How to Carry Bikes While Towing a Travel Trailer
- Article: Best Air Bag Suspension (2023)
- Article: How Your RV Water System Works: A Complete Newbie's Guide
- Article: Best Bike Racks for Electric Bikes
- Article: Stability Control for Heavy Duty Vehicles