Torque Spec For Nut of Curt Hitch Ball Part # A-82
Question:
how tight should the shank be on the hitch, there is a cotter pin
asked by: Ken
0
Expert Reply:
I spoke to my contact at Curt and he informed me that the torque spec for the nut of the Curt Hitch ball part # A-82 is 160 ft lbs of torque.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
2" Hitch Ball - 3/4" Diameter x 2-1/8" Long Shank - Stainless Steel - 3,500 lbs
- Trailer Hitch Ball
- Trailer Hitch Ball
- Standard Ball
- Stainless Steel
- 2 Inch Diameter Ball
- 2-1/8 Inch Shank Length
- 3/4 Inch Diameter Shank
- 3500 lbs GTW
- Class I
- Class II
- CURT
more information >
Continue Researching
- Q&A: Parts Needed to Add Brake Controller to 2024 Toyota Sienna Platinum
- Q&A: Trailer Break Control Installation for Tekonsha Prodigy P3 on 2019 Mercedes-Benz Sprinter 3500
- Q&A: Recommended Sway Control Option for Small Trailer
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Trailer Hitch and Wiring Recommendation for 2018 Ford Focus ST Hatchback
- Q&A: Ball Mount Compatibility with Trailer Hitch Receiver on 2012 Kia Soul
- Q&A: Why Can't Class II Accessories Be Used with Class I Trailer Hitch Receiver
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Ball Mount Basics: Weight Capacity, Class, and Size
- Q&A: Recommended Trailer Hitch, Wiring, and Ball Mount for 2016 Hyundai Veloster
- Article: Trailer Lighting Requirements
- Article: How to Choose the Right Trailer Hitch Class
- Article: How to Back Up a Trailer
- Article: Which Hitches are Made in the USA