Hitch Lock for a Kuat Bike carrier with 3/8 Inch Diameter Hitch Pin

Question

Question:

do you know if the thule snug tight lock is available as just the lock and key to fit the Kuat racks pin?

asked by: Mike

0

Expert Reply:

So the Thule Snug Tite lock # THSTL2 does not fit the Kuat pin because the Kuat pin is a 3/8 inch diameter. It is too small to fit the Thule lock. Kuat has a locking pin, # HL1. It fits 3/8 inch diameter pin holes. It has a useable length of 3-1/2 inches. The lock part is not available by itself.

expert reply by: Michael H

0

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

view full answer...

Answer 6

The correct hitch lock for your Kuat Transfer V2 Bike Rack for 1 Bike - 1-1/4" and 2" Hitches - Wheel Mount #KU64FR is the Hitch Lock for Kuat Bike Racks - 2" Hitches #HL1. This will allow you to lock the Transfer V2 to your vehicles…

view full answer...

Answer 7

Thanks for reaching out, Tripp! To get multiple locks keyed alike that are compatible with the Demco EZ-Latch you'll need to go with our etrailer Surge Brake Coupler Lock #e98888 - just be sure to choose the "keyed alike" option from…

view full answer...