What Do the Connectors of the # 118415 Plug Into When Installing on Hyundai Santa Fe
Question:
There two connectors coming off of each side of the bundled wires. A female and a male. The video only shows connecting to the female. Where does the male connector go?
asked by: Steve K
0
Expert Reply:
The reason the connection you mentioned wasn't shown in the attached video is because the factory connector that male side of the # 118415 plugs into is behind the panel of the vehicle which makes filming it difficult.
Basically you will unplug the factory taillight harness of your vehicle and then will install the connectors of this harness in between them.
You can see it better in the install instructions link I attached.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Converter
- Custom Fit
- 4 Flat
- Tekonsha
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Ball Mount Recommendation for 2012 Kia Forte Curt Trailer Hitch and 2 Hitch Ball
- Q&A: Wheel With 15 Diameter and 5 on 5-1/2 Bolt Pattern Needed for Antique Camper Trailer
- Q&A: How to Determine if 2017 Jeep Compass is New or Old Body Style for Picking Out Hitch
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Q&A: Lug Nut Torque for Aluminum Wheel 15 Inch Diameter
- Q&A: Can a 2016 Riverside Whitewater Retro 155XL Be Raised for More Ground Clearance
- Q&A: How Do I Tell if My Hyundai Santa Fe Has a Tow Package?
- Article: Trailer Wiring Diagrams
- Q&A: Solution for Replacing Dexter 8-222 Trailer Hubs and Bearings
- Article: Measuring a Trailer Tire
- Article: My Trailer Hitch Doesn't Fit
- Article: What Do I Need To Tow A Trailer?
- Article: Trailer Hitch Receiver Sizes
- Article: How to Clean Weld Nuts for the Installation of a Trailer Hitch | etrailer.com