Does Fascia Bracket of 2010 Ford Edge Get Reused After Hitch Install
Question:
Does the fascia bracket ever get reattached?
asked by: Doug
0
Expert Reply:
The fascia bracket of your 2010 Ford Edge will get bent back and not reused once you install the Hitch part # 75992 that you referenced.
Check out the install video I attached for more info as well.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class III
- 400 lbs TW
- 4000 lbs GTW
- 4000 lbs WD GTW
- 2 Inch Hitch
- 400 lbs WD TW
- Concealed Cross Tube
- Draw-Tite
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Wheel To Replace Discontinued Lionshead Black Tiger Wheel for Camper
- Q&A: I A Latch For My RV Door That Has A 4-1/2 inch X 4-1/2 inch Hole
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: Recommended Replacement Grease Seal for 2014 Shorelander Boat Trailer
- Q&A: Trailer Hitch Receiver and 4-Way Flat Vehicle Wiring Harness For a 2024 Ford Maverick
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Does the Ventline Exterior Wall Vent for RV Range Hood # V2018-01 Have a Screen
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Why Is a 10" Lube Plate Recommended for a B&W Companion Instead of 12"
- Article: My Trailer Hitch Doesn't Fit
- Article: How to Correct Noise from Exhaust Rattling Against a Trailer Hitch
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Article: Best Bike Racks for Fat Bikes
- Article: How to Choose a Bike Rack for an SUV or Crossover