Do Diamond # DI34ZR Load Resistors Get Hot
Question:
Dear Etrailer, Ineed the following product to stop the hyperflash turn signal problems Ive with my 2007 Dodge Durango: * Putco Accessories and Parts - P230004C-2 * I would Like to confirm if these products get really hot and do I have to fix them to metal just like the normal 50W load resistors. Thank you and I look forward to response. Kind Regards, Krigbo
asked by: Krigbo
0
Expert Reply:
Load resistors can reach between 140-160 degrees Fahrenheit. Therefore, mounting them to a plastic surface wouldn't be a good idea. Mounting them to a metal surface is recommended.
expert reply by:
Mike L
0
Product Page this Question was Asked From
Load Resistor Kit for LED Turn Signals - 50 Watts - 6 Ohm - Qty 2
- Accessories and Parts
- Trailer Lights
- Load-Resistor Kit
- Diamond
more information >
Continue Researching
- Q&A: Solution for Rapid Signal Flashing on Utility Bed with LED Lights
- Q&A: LED Tail Lights Added to Flat Bed Truck Hyper Flash with Flashers/Turn Signals On
- Q&A: Are Load Resistors Required when Adding LED Lights to a Trailer
- Q&A: Are Load Resistors Needed for LED Backup and Brake/Tail Lights
- Q&A: What Is The Depth Of The Ventline Pinnacle Ductless RV Range Hood VE78SR
- Q&A: How Do I Install Load Resistors for the LED Lights on my 2007 Dodge 3500 Flatbed
- Q&A: AC Shroud Replacement for Coleman Mach 7333A887
- Article: Gooseneck to 5th Wheel Adapters
- Article: Top Weight Distribution Hitches for a Buttery Smooth Ride
- Article: Trailer Wiring Diagrams
- Article: Replacing RV Awning Fabric: Your Step-by-Step DIY Guide
- Article: Best Boat Accessories
- Article: Which Hitches are Made in the USA
- Article: 5 Things to Know About Weight Distribution Hitches