Brake Controller Recommendation for a 2014 Dodge Durango Limited without 7-Way
Question:
Hello, I am looking to put in an electric brake controller into my 2014 Dodge Durango Limited. I am looking at the plug and play part # 3045-P wiring connector. I am confused as to how this would enable me to get a brake signal back to the 7 pin connector. Do I need to tap somewhere else into the factory harness to get this or what? I have the factory trailer harness coming which has the blue wire for trailer brakes. Where do I grab the output from the brake controller if I use this wiring adapter? Thank you,
asked by: Tom M
Expert Reply:
If you do not have a factory 7-way at the rear of your 2014 Dodge Durango you would need to go a different route to install a brake controller instead of the # TK93VR.
You will need to start with a 4-way (if you do not have one). For that you would want the # 118617.
From there you would need to convert the 4-way to a 7-way so that you can install the brake controller. For that you will want the Brake Controller Install Kit and 7-Way Adapter part # ETBC7. I attached installation instructions and an install video for this product as well.
For a brake controller I would recommend the Prodigy P2 Brake Controller part # 90885. This is our best selling brake controller because of how well it works and how easy it is to setup.
Products Referenced in This Question
T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Powered Converter
- Custom Fit
- 4 Flat
- Tekonsha
more information >
Tekonsha Prodigy P2 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Electric over Hydraulic
- Automatic Leveling
- Under-Dash Box
- Dash Mount
- Up to 4 Axles
- LED Display
- Up to 360 Degrees
- Tekonsha
more information >
Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Accessories and Parts
- Trailer Brake Controller
- Installation Kits
- etrailer
more information >
Product Page this Question was Asked From
Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers
- Accessories and Parts
- Trailer Brake Controller
- Wiring Adapter
- Plugs into Brake Controller
- Tekonsha
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Recommended Replacement for Atwood Surge Brake Actuator 85778
- Q&A: Solution for Atwood Surge Brake Coupler Needing Replacement Parts
- Q&A: Recommended Dexter Suspension Kit 7753400
- Q&A: Options for Adding Interior Lighting to Enclosed Cargo Trailer
- Q&A: How to Power Trailer Dome Light When Not Connected to Tow Vehicle
- Q&A: Location of the 40-Amp Fuse for the 2006 Chevrolet Silverado Tow Package
- Q&A: Fuse Location for Trailer Brake Controller on a 2005 Chevy Silverado
- Article: Our Team Picked The Best Camping Gear of the Year - Here Are Their Top Choices
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Brake Controller Installation: Starting from Scratch
- Article: Pintle-Hitches
- Article: Big Truck Big RV
- Article: Flat Towing Package for 2008-2011 Honda CR-V
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)