ETBC7 Installation Recommendation for a 2005 Chrysler Town and Country

Question:

I have a question about installing wiring in my 2005 Chrysler Town and Country minivan so that it connects to my trailers wiring. I have installed a CQT118300 Quick Connect kit in my minivan, and stowed the 4-way flat connector in its jack storage compartment, as suggested by your installation video. I am now installing an ETBC7 Brake Controller Harness in the same vehicle. My question is: What is the recommended way to route the 4-way flat connector from the CQT118300 Harness inside the car, so that it plugs into the 4-way flat connector beneath the car? Thanks,

asked by: Larry W

Helpful Expert Reply:

You will need to find a hole in the floor of the rear cargo area of your 2005 Chrysler Town and Country so that you can route the 4-way out through the bottom. You may have to drill a hole if there is nothing there, but there should be a rubber plug or grommet that would allow you to route the 4-way through the floor of the trunk.

I attached an install video that shows the # ETBC7 being installed in a similar vehicle for you to check out as well.

expert reply by: Jameson C