Why Do Trailer Brakes have to be Bled After 100 Miles Using the Titan Brakerite EHB
Question:
The manual says to bleed the brakes then bleed them again after 100 miles. Why would they have to be bled twice ???
asked by: Marty C
1
Helpful Expert Reply:
After a certain amount of use after the initial installation you will want to bleed the brakes again to ensure that there is no air in the system and that everything is still working properly with the Titan BrakeRite # T4813102 and the brakes. After that you would just follow a regular maintenance schedule.
expert reply by:
Michael H
1
Product Page this Question was Asked From
Dexter BrakeRite II Electric Over Hydraulic Actuator Kit - Vented - 1,500 psi
- Brake Actuator
- Electric-Hydraulic Brake Actuator
- Disc Brakes
- Dexter
more information >
Continue Researching
- Q&A: How Do I Measure the Drop Distance on a Trailer Drop Axle?
- Article: How to Replace or Install an RV Roof Vent
- Q&A: Replacement Disc Brake Caliper for a Tie Down Engineering 46304 Caliper
- Q&A: Replacement For Dexter DX12.5 Brake Actuator on Boat Trailer
- Q&A: Replacement RV ladder for 2007 Monaco Diplomat
- Article: Adding Electric Over Hydraulic Disc Brakes
- Q&A: Replacement Hub Needed for Lippert 122093 Hub on 5,200 lbs Axle
- Q&A: Will the Draw-Tite Trailer Hitch Fit a 2022 Volvo XC90 Recharge
- Article: How to Charge a Trailer Battery While Driving: 3 Common Problems (And How to Fix Them)
- Q&A: Comparison between Kuat Transfer and Swagman Chinook Bike Racks
- Article: Trailer Wiring Diagrams
- Article: Parts Needed to Add Hydraulic Disc Brakes to a Trailer
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: 2023 Best Gifts for Outdoor Enthusiasts