Electric Brake Controller Recommendation for 2004 Winnebago 38G

Question:

Hi, According to Winnebago, my Workhorse unit is pre-wired for an electronic brake controller as shown in attached photo that they provided. Is any kind of adaptor or wiring harness required to interface the Prodigy P2 controller to what they provide and if so where should I go to get it? Thanks,

asked by: Tyler G

Expert Reply:

The picture you referenced didn't make it through, but I am assuming it is a harness with 4 blunt cut wires for easy installation of a brake controller. To install the P2 # 90885 all you would need to do is wire the included harness directly to the connector you have.

Here are the functions of the wires on the P2:

blue is brake output
red is stoplight circuit
white is ground
black is 12 volt power

expert reply by: Jameson C