Tubing Size and Wall Thickness of Pro Series 5K Square Tube Trailer Jack # PS1400850383
Question:
what is the thickness of the square tubing
asked by: Gerry
0
Expert Reply:
The outer tube has an outside width of 2-1/2 inches, the inner tube has an outside width of 2 inches. The wall thickness of the tubing is between .098 - .110 of an inch.
expert reply by:
Mike L
0
Product Page this Question was Asked From
Pro Series Square Jack with Footplate - Drop Leg - Sidewind - 28-11/16" Lift - 5,000 lbs
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- Leveling Jacks
- Tongue Jacks
- Steel
- 4001 - 5000 lbs
- Sidewind Jack
- 29 Inch Lift
- Weld-On
- With Rectangle Foot
- Pro Series
more information >
Continue Researching
- Shop: CE Smith Trailer Idler Hub Assembly w/ Case for 3.5K Axles - 5 on 4-1/2 - Galvanized - Pre-Greased
- Search Results: trailer coupler
- Shop: Wesbar 4-Way Flat Trailer Wiring Harness - 20' Long
- Shop: Dexter Trailer Axle with Idler Hubs - 5 on 4-1/2 Bolt Pattern - 89" Long - 3,500 lbs
- Shop: Dexter Trailer Axle Beam w/ Idler Hubs - 4" Drop - E-Z Lube - 5 on 4-1/2 - 89" Long - 3.5K
- Shop: Trailer Axle with Idler Hubs - 4" Drop - 5 on 4-1/2 Bolt Pattern - 95" Long - 3,500 lbs
- Shop: Trailer Tongue Vertical Channel Weld-On Adaptor with 6 Bolt Holes - Welded
- Shop: Buyers Products Coupler w/ 5-Position Adjustable Channel - Weld-On - 2" Ball - 10,000 lbs
- Article: Trailer Tire Sizing
- Video: M-3 Exterior LED Utility Light Review and Installation
- Search Results: metal vent
- Search Results: aps3se
- Search Results: ez latch coupler
- Search Results: running lights
- Search Results: clearance lights
- Search Results: demco coupler
- Q&A: What Gauge Wire does 4-Way Trailer Wiring Use
- Q&A: Does 2022 Chevy Silverado Need Adapter For Dexter DX EOH Actuator & Factory Brake Controller
- Q&A: Measurements on the Channel Tongue Trailer Coupler
- Q&A: Trailer Jack for Trailer With Non-Traditional Trailer Tongue
- Q&A: Brainstorming Sidewind Trailer Jack for 2 Inch Receivers On Cargo Trailer Corners For Stabilization
- Q&A: Dutton-Lainson Square Swivel Jack Mounting Plate Bolt Pattern I will be us
- Q&A: Can Pro Series Square 8K Trailer Jack be Welded to a Trailer Frame
- Article: Trailer Couplers
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
- Article: Trailer Wiring Diagrams