SH On Prodigy Brake Controller But Trailer Brakes Work Fine with Different Tow Vehicle
Question:
I recently bought a new trailer, pulled it with 2008 F250 integrated brake controller and the brakes work fine. When hooked to my RV with a Prodigy controller I get an SH code.
asked by: Timothy D
Expert Reply:
The SH error on the Prodigy series of brake controllers indicates that the controller is sensing a short. Since it worked fine with your truck the likely culprit is a dirty or corroded trailer connector on the RV.
Make sure that the RV side and trailer side connectors are clean and free of corrosion inside where the wires attach and on the pins. Be sure to fix or replace any questionable wires as well.
If this does not solve the problem you can test the brake controller using the help articles I have linked for you.
Product Page this Question was Asked From
Replacement Magnet Kit for 12" Electric Trailer Brake Assemblies - 5,200 lbs to 7,000 lbs
- Accessories and Parts
- Trailer Brakes
- Electric Drum Brakes
- 5200 - 7000 lbs
- Brake Magnets
- 12 Inch
- etrailer
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: Most Popular Wheel Bearings
- Article: Trailer Wiring Diagrams
- Q&A: Trailer Brakes are Very Weak Even After Adjusting Them
- Q&A: How to Confirm Correct Size of Grease Seal
- Q&A: What Ohms Should Trailer Brake Magnets Be?
- Article: Trailer Tester Battery Replacement for Part Number 8010
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Replace Trailer Leaf Springs in 5 Steps
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
- Q&A: Difference Between Single, Dual and Free Backing Servo Brake Assemblies
- Q&A: Troubleshooting Trailer Brakes Getting Only 8 Volts Of Power
- Q&A: How to Determine Correct E-Z Lube Grease Cap
- Q&A: Comparing the E-Z Lube Hubs to the Standard Hub Assemblies for Trailer Axles