Does the Spare of a 2000 Mitsubishi Get Reinstalled After Trailer Hitch Install
Question:
Just installed 13223. The spare tire wont fit back up. It squeezes in too tight between the back of the hitch and a round cross bar on the front side. Any suggestions?
asked by: Dale H
0
Expert Reply:
Sometimes after you install a hitch when you go to reinstall the spare tire you end up having to angle the spare as you raise it back into position so that it will fit correctly.
Check out the install video I attached for this hitch that shows our installer removing the spare and then reinstalling it once the hitch has been installed.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class III
- 500 lbs TW
- 5000 lbs GTW
- 6000 lbs WD GTW
- 2 Inch Hitch
- 600 lbs WD TW
- Visible Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: My Trailer Hitch Doesn't Fit
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Grounding T-Connector for 1995 Jeep Grand Cherokee
- Q&A: How To Wire a Trailer Harness on a 2000 Mitsubishi Montero
- Article: Trailer Wiring Diagrams
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: Brake Controller Installation: Starting from Scratch
- Q&A: Recommended Tire Size to Replace 235/70 R15 Sized Tires on a Horse Trailer
- Q&A: What is the Towing Capacity for a 2001 Subaru Outback and Trailer Hitch and Wiring Recommendations