What Size Hinge Pin Is Used With Redline Enclosed Trailer Ramp Spring
Question:
I purchased to of your ramp springs a would like to know the pipe size because when the ramps are down does the springs tighten up around the pipe.
asked by: Donald T
0
Expert Reply:
The springs you mentioned, part # RS16933RH and part # RS16933LH are designed for use on an existing door hinge that uses a 1-1/2 diameter rod or pipe as a hinge pin.
These are made of steel alloy and provide 90 degrees of deflection. I have attached a product review video for this ramp spring you can check out.
expert reply by:
Jeffrey L
0
Products Referenced in This Question
Ramp Spring - 2K Torque for 1-1/2" Round Shaft - LH
- Trailer Ramp Springs
- Single Ramp Spring
- Left Hand Spring
- 11 Inch Wide Spring
- Steel Alloy
- Redline
more information >
Product Page this Question was Asked From
Ramp Spring - 2K Torque for 1-1/2" Shaft - RH
- Trailer Ramp Springs
- Single Ramp Spring
- Right Hand Spring
- 10 Inch Wide Spring
- Steel Alloy
- Redline
more information >
Continue Researching
- Q&A: Choosing/Sizing the Correct Trailer Ramp Spring for a Ramp Door
- Q&A: Mounting Bolt Pattern for Demco Channel Tongue Coupler
- Q&A: Replacement Hub for Hammer Blow Hub Part HB732 on Old Trailer
- Q&A: Is 2K Rating for Redline Ramp Spring is Under a Load
- Q&A: How Do the Heavy Duty Ramp Springs Install on a Trailer and Ramp
- Q&A: Recommended Gate/Ramp Assist and Hinge for Trailer Build
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Best RV Roof Vents
- Article: 2022 Best Stocking Stuffers
- Article: Best Tire Chains
- Article: 2023 Best Gifts for Haulers & Towers
- Article: How to Choose the Right Trailer Hitch Class