Available Replacement Winch Handle for Fulton T1801 Hand Winch

Question:

Is the hole in the winch handle round or square? I think my handle has been rounded out: Not sure: Do known that shaft of winch where handle slides over has a flat surface: Thanks for time and consideration of this matter:

asked by: Jerry K

Expert Reply:

The hole in the handle is slotted, and is meant to replace the handle on a Dutton-Lainson DL1400 or DL1402 winch.

The proper replacement for your Fulton T1801 winch would be the Fulton Replacement Winch Handle, part # F501109 or # F501110 depending on the length that you prefer. To make absolutely sure we got you the correct replacement handle, I have confirmed this with my Fulton representative.

expert reply by: Mike L