Recommended Time-Delayed Brake Controller For Motorcycle Towing Camp Trailer With Electric Brakes
Question:
Will the prodigy p3 work on motorcycle trailer? I was needing a brake controller to pull a timeout camp trailer behind my 2015 ultra classic low. Flhtkl. Electric 7inch brakes. Thanks
asked by: Paul H
Helpful Expert Reply:
The Prodigy P3 brake controller, part # 90195 is a great brake controller and one of our best sellers, but for a motorcycle you might be better off using a time delayed brake controller.
The brake controller I recommend is the Draw-Tite Activator IV Trailer Brake Controller, part # 5504 because it is smaller than most other controllers at 4-3/16 inches long x 2-3/4 inches wide x 1 inch tall. The advantage of a time-delayed controller is that you can mount these at any angle versus the proportional controllers that require the brake controller to be mounted a certain way. When motorcycles navigate curves, many times they are tilted. You can mount the # 5504 so that the manual over ride is within easy reach for even more control.
To wire the brake controller you will need a 20 amp circuit breaker like part # PK54220, installed inline on the black power wire that goes to the motorcycle battery. The white wire should be attached to a good bare metal surface, and the red wire will need to be attached to a brake light signal that shows current only when the motorcycle brakes are activated. Last, you will need some blue 10 gauge wire, part # 10-1-1. This will be used to extend the blue wire from the brake controller to the trailer connector on the motorcycle.
You may want to use a circuit tester like part # PTW2993 to check the trailer connector on the trailer and motorcycle to make sure they are aligned properly.
Products Referenced in This Question
Tekonsha Prodigy P3 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Electric over Hydraulic
- Automatic Leveling
- Under-Dash Box
- Dash Mount
- Up to 4 Axles
- LCD Display
- Up to 360 Degrees
- Tekonsha
more information >
Circuit Breaker - 20 Amp - Perpendicular Mount Bracket - Cycling Auto Reset - Metal - Type I
- Accessories and Parts
- Wiring
- Circuit Breaker
- 20 Amp
- Pollak
more information >