Why Does Hopkins Active Tail Light Converter 46255 Require a 12V Power Connection to Vehicle Battery
Question:
Hi I have ? For p# 46255 for Acura TL 2012 , on old model you dont need run wire from battery to trunk why on 2012 you need power from battery , it is lots work to run wire from battery to trunk is any way I can skip that , I installed hitch and install wire kit p# 46255 tha only I didnt connect that wire red with black stripe to battery , same way on my old car but none of the light working can you help , thank you
asked by: Slava
Helpful Expert Reply:
There are two types of trailer wiring harnesses. There are passive types that do not have a 12V power connection; these use your car's own wiring to deliver the power to operate your trailer's lights. And there are active types that have a powered converter, such as the Hopkins # 46255 that you have; these use the car wiring only to carry switching signals to tell the converter when to send out power for the trailer. The actual power for the trailer lights comes from the car's battery, but NOT through its own wiring.
This powered type of converter does a much better job of protecting your car's delicate wiring from excessive power draw from the trailer lights or from a short in the trailer wiring. For your 2012 Acura TL only this type of powered converter is offered. This is because the car's wiring is not considered heavy enough to carry the power drawn by the trailer lights.
We do have a helpful article that shows ways to route that power wire on the TL. I also linked a video for a similar harness, part # 46255, that shows its installation.
Wiring harnesses of this type will not operate unless the 12V power connection is made.
Product Page this Question was Asked From
Hopkins Active Tail Light Converter with Install Kit
- Trailer Wiring
- Trailer Connectors
- Vehicle End Connector
- Plug and Lead
- 4 Flat
- Hopkins
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Does Curt Hitch C12130 Fit 2008 Mercury Grand Marquis
- Q&A: Replacement 1998 PJ Utility Trailer Hub with QRG 3G and 84000 Stamped Into Hub
- Article: How to Measure for Trailer Hitch Drop
- Article: My Trailer Hitch Doesn't Fit
- Article: How to Choose the Right Trailer Hitch Class
- Article: Ball Mount Basics: Weight Capacity, Class, and Size
- Q&A: Ground Clearance Measurement for Trailer Hitch on 2005 Audi A6
- Q&A: Will Curt Trailer Hitch # C11497 Fit 2006 Subaru Impreza STi?
- Q&A: Replacement Trailer Hub Seal for 12194TC TCM
- Q&A: Trailer Hitch and Wiring for a 2004 Ford Escape without Factory Tow Package
- Q&A: Semi Trailer Light Function Locations on Heavy Duty 7-Way Pin Connection
- Article: Which Hitches are Made in the USA