How to Pick Out Bearings for a Trailer
Question:
I have a tent camper that has one side in bad need of repair. I have pictures attached of the area in question, and the identification sticker on the side. I dont have the tools to take the wheel off and see what size the bearings are. I hope you can tell me by looking up the model or VIN number on the sticker. Its a flagstaff by forest river pop up camper. Also I need to know how to make sure it doesnt happen again. What grease do I need, etc. The other side looks fine but Im sure ill need to grease that too as I havent since Ive owned it, and its been probably 1000 miles traveled since then. Couldnt say when they were greased before then. Thanks.
asked by: Nick D
Expert Reply:
I really wish there was a way to determine what bearings a trailer needed without actually pulling the wheel off and checking, but there isn't. The only two solution I have for you would be to remove the hubs and get the numbers that are stamped on the bearing or for you to remove the hubs and use a digital or dial caliper to measure where the bearings and seal ride (see pic).
With that info I can help you figure out what you need.
The best grease to use in a hub assembly is the "red" grease like part # L11390. This grease is the most heavy duty and would work well for you.
Products Referenced in This Question
LubriMatic LMX Industrial Strength Grease - 14 oz. Cartridge
- Lubricants Sealants Adhesives
- Grease
- Brake and Bearing Grease
- Standard Lithium Grease
- Lithium Complex
- 14 oz
- LubriMatic
more information >
Product Page this Question was Asked From
Dexter Trailer Idler Hub Assembly for 2,000-lb Axles - 5 on 4-1/2
- Trailer Hubs and Drums
- Hub
- Standard
- L44643
- L44643
- For 2000 lbs Axles
- 5 on 4-1/2 Inch
- 13 Inch Wheel
- 14 Inch Wheel
- 14-1/2 Inch Wheel
- 15 Inch Wheel
- Dexter
more information >
Continue Researching
- Q&A: Recommended Replacement Hubs for Harbor Freight Trailer
- Q&A: How to Determine the Size of a Trailer Hub Assembly for Replacement
- Q&A: Replacement Idler Hub For Old Boat Trailer With DICO 45264 Idler Hubs
- Q&A: Can Jayco Pop Up Trailer with 4 Lug Hubs be Swapped to 5 Lug Hubs
- Q&A: Difference Between an Idler Hub and a Hub/Drum
- Article: Most Popular Wheel Bearings
- Q&A: Replacement Hub for DICO 45264
- Q&A: Replacement Bearings and Seal for Freedom Axle 45264 Hub Assembly
- Article: Trailer Tire Sizing
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: Trailer Wiring Diagrams
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub