Differences Between Time Delayed and Proportional Brake Controllers
Question:
What is the diff. between brake controller s I will be pulling 38foot fifth wheel camper with 2 axles
asked by: Don G
Expert Reply:
There are two main styles of brake controllers. There are the time delayed models and the proportional models.
A time delay controller is so named because there is a delay between the time that you initially apply the brakes in your tow vehicle and the time that the controller reaches maximum power output. Unlike a proportional brake controller, which activates your trailer's brakes based on the deceleration of your tow vehicle, a time-delayed controller sends power out in the same way, with the same gradual delay, no matter the braking situation. Although this delay always exists, it can be adjusted by changing the sync setting.
A time-delayed brake controller doesn't rely on internal parts to sense braking motions of the tow vehicle. This allows you to mount the controller at any angle.
Every time you apply the brakes in your tow vehicle, a signal is sent to the brake controller. The controller then sends voltage back to the trailer brakes to power them at the level set by the user and at a rate chosen by the user.
The amount of braking power and rate of application (how quickly the power ramps up) can be adjusted to fit personal preference, road conditions, type of trailer, and size of the load. To determine which levels are best for your application, you must test out your towing setup and choose what feels best.
A proportional brake controller senses when and how your tow vehicle brakes with an internal inertia-based sensor. This sensor responds to the deceleration of your tow vehicle as you brake by signaling the controller to send out enough power to your trailer brakes so that they are activated with an intensity that matches. The result is uniform braking across your towing setup. No push-pull action - just smooth, proportional braking every time.
With a proportional brake controller, such as # 90885, you can get heavy-duty emergency braking, general braking, or slow-to-an-idle braking for your trailer automatically. The intensity with which your trailer brakes are activated and the rate at which they are applied are dependent on the deceleration of your tow vehicle. This means that, unlike time-delay controllers - which send the same amount of preset power to your trailer brakes every time - proportional controllers are able to adapt to every braking situation differently. So if you slam on the brakes in your truck, your trailer brakes will activate with the same extreme intensity. And if you merely slow down as you approach a red light, your trailer will gradually brake in the same manner.
To install the # 90885 all you would need is the correct install adapter, part # 3034-P. This is basically the best setup around so I would highly recommend it for you.
I attached a help article on brake controller for you to check out as well.
Products Referenced in This Question
Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers - Ford
- Accessories and Parts
- Trailer Brake Controller
- Wiring Adapter
- Plugs into Brake Controller
- Vehicle Specific
- Tekonsha
more information >
Product Page this Question was Asked From
Tekonsha Prodigy P2 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Electric over Hydraulic
- Automatic Leveling
- Under-Dash Box
- Dash Mount
- Up to 4 Axles
- LED Display
- Up to 360 Degrees
- Tekonsha
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Brake Controller Installation: Starting from Scratch
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Install a Brake Controller on Chevrolet / GMC 1999-2006 Pickups
- Article: 5 Things to Know About Weight Distribution Hitches
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Q&A: Parts Needed To Install A Brake Controller On A 2023 Freightliner Cascadia
- Q&A: Brake Controller Recommendation for a Truck with Air Brakes and a Trailer with Electric Brakes
- Q&A: Parts Needed to Install 7-Way/4-Way on 2024 Kia Telluride with LED Taillights
- Q&A: How do I Tell if the Brake Controller is Bad
- Q&A: How Is Spring Bar Tension Set Up with Trailer Weight Distribution System
- Q&A: Lift Kit Options For A 2015 Winnebago Micro Minnie 1706FB