Dimensions of Flexco Manual Pull-Out Steps for RVs # SMFP-4400
Question:
I need a manual pull-out quad step in a 7 or 8 rise. The SMFP 4400 is too wide to fit into the slot of the 3 step I want to replace. The existing space is 27 3/8 . The 4400 looked the most sturdy. What do have there that will fit my application? The trailer is a 2012 Sanibel 3500. Thank you
asked by: Ed C
Helpful Expert Reply:
The bolt to bolt distance on the Flexco Manual Pull-Out Steps for RVs, # SMFP-4400, measures 28-1/8 inches and the sliding bolt at it's highest point is approximately 3-1/2 inches below the mounting base. I have attached a dimensional diagram for you.
Products Referenced in This Question
Lippert Manual Pull-Out Step for RVs - Triple - 7" Drop - 25-3/4" Wide - Steel - 300 lbs
- RV Steps
- Towable Camper
- Pull-Out Step
- 24 Inch Wide Step
- 27-1/2 Inch Wide
- 3 Steps
- 7 Inch Drop/Rise
- No Ground Contact
- Steel
- Lippert
more information >
Product Page this Question was Asked From
Flexco Manual Pull-Out Steps for RVs - Quad - 8" Drop/Rise - 24" Wide - 300 lbs
- RV Steps
- Towable Camper
- Pull-Out Step
- 24 Inch Wide Step
- 28-1/8 Inch Wide
- 4 Steps
- 8 Inch Drop/Rise
- No Ground Contact
- Steel
- Stromberg Carlson
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Trailer Light Replacement Lens for Light Marked SAE-A-P2-DOT-02
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Q&A: Can Base Plate Kit And Grille Guard Both Be Installed On 2021 Jeep Wrangler
- Q&A: Dimensions of the Flexco Steps Part # SMFP-4400
- Q&A: Replacement for High Pointe 50f11 Range Hood
- Q&A: Replacement Drain Plug For An Atwood G6A-7 Water Heater
- Q&A: RV Step Recommendation that Can Fit 27 inch Wide Mounting Brackets
- Article: RV Propane Troubleshooting | Common Propane Issues and How to Solve Them
- Q&A: Replacement Fan Motor for Greystone RV Range Hood with Light 12V
- Article: 2 Steps for Finding the Right Weight Distribution Hitch Size
- Article: How (and Where) to Connect an RV Propane Grill
- Article: How to Measure for Motorhome Steps
- Article: The Best Towing Mirrors
- Article: The 5 Best Trailer Drop Hitches You Can Buy
Ed C.
4/7/2015
I need a manual pull-out quad step in a 7 or 8 rise. The SMFP 4400 is too wide to fit into the slot of the 3 step I want to replace. The existing space is 27 3/8 . The 4400 looked the most sturdy. What do have there that will fit my application? The trailer is a 2012 Sanibel 3500. Thank you