Why Would the Lynch Pins of a Swagman XTC2 Be Hard to Insert
Question:
Should it be difficult to put the lynch pins in and out. Im tempted to tap it with a hammer...but thinking that is not a good idea. Is there a secret?
asked by: Jeff D
0
Expert Reply:
The lynch pins of the Swagman XTC2 Bike Rack part # S64670 should not be difficult enough to insert that you would need to use a hammer. If they are being that difficult to install then the holes of the rack must not be lined up properly. Try positioning the arms or the upright of the rack around so that the holes are lined up better before you insert the pins.
expert reply by:
Jameson C
0
Products Referenced in This Question
Swagman XTC2 Bike Rack for 2 Bikes - 1-1/4" and 2" Hitches - Frame Mount
- Hitch Bike Racks
- Platform Rack
- Folding Rack
- Frame Mount
- Locks Not Included
- 2 Bikes
- Class 2
- Fits 1-1/4 Inch Hitch
- Fits 2 Inch Hitch
- Fits 1-1/4 and 2 Inch Hitch
- Swagman
more information >
Product Page this Question was Asked From
Replacement Pin and Tether for Swagman XC and XTC Series Bike Carriers
- Accessories and Parts
- Hitch Bike Racks
- Pins and Clips
- XC
- XTC
- Swagman
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Can the Ratcheting Arms on the Swagman XC Trailer Hitch Mount Bike Rack be Locked
- Q&A: Recommended Hose Assembly For 500-Gallon Propane Tank To Fill 20-Lb Portable Tanks
- Q&A: Are Swagman Locking Ratchet Hooks Compatible with Swagman Traveler XCS Bike Rack?
- Q&A: Replacement Power Converter for WFCO-8560
- Article: 2023 Best Gifts for RVers & Campers
- Q&A: Rooftop Tent Compatibility on 2012 Nissan Xterra Factory Roof Rack
- Q&A: Comparing Brophy Camper Tie Downs # HSSF and # HSAB
- Q&A: Replacement Clip for Swagman XTC2 Bike Rack
- Article: Rolling on a Budget: Top Wallet-Friendly Platform Bike Racks