Fuse Bypass Recommendation for a 2013 Honda CR-V for Flat Towing

Question

Question:

Which fuss bypass swich should I use on a2013 Honda cr v

asked by: Louis K

1

Helpful Expert Reply:

I checked with Roadmaster and the recommended fuse bypass kit is the part # RM76512 for your 2013 Honda CR-V.

I attached a couple help articles on flat towing for you to check out as well.

expert reply by: Jameson C

1

Answer 1

On your 2014 Honda CR-V, when your remove the key you will need to go through the entire process again. I've attached the photo of the owners manual page to assist. This will help you to circulate the fluids and allow the vehicle to be towed…

view full answer...

Answer 2

The Roadmaster FuseMaster Fuse Bypass Switch part #RM76512 is indeed needed for a 2012 Honda CR-V regardless of whether or not a battery charge line like the Roadmaster Battery Charge Line Kit for Towed Vehicles part #RM-156-25 is used. The purpose…

view full answer...

Answer 3

Short answer is yes. You will need to check your owners manual to verify if you need to remove one fuse of two. It just depends on how they set that version up. If you need to bypass one use the Roadmaster FuseMaster Fuse Bypass - 13" - 20-Amp…

view full answer...

Answer 4

The "radio" fuse of your 2014 Honda CR-V will need to be pulled and replaced with the Roadmaster FuseMaster Fuse Bypass part #RM76511. This product will make it easy to deactivate this circuit, you will only need to flip a switch instead of…

view full answer...

Answer 5

The correct fuse bypass switch to use on your 2014 Honda CR-V is the Roadmaster FuseMaster Fuse Bypass Switch part #RM76512. I attached some flat towing FAQ articles for you to check out also. The fuses that need to be pulled from the instrument…

view full answer...

Answer 6

If you look in the owners manual for your 2013 Honda CR-V it will tell you what fuse to pull and where it is located so you can flat tow your CR-V. From what I could find it is the accessory radio fuse that has to be pulled from the interior fuse…

view full answer...

Answer 7

The BrakeBuddy Towed Vehicle Battery Charge Kit part #BB54FR comes with a the Brake Buddy Select 3 Portable Supplemental Braking System part #HM39524. I have attached a wiring diagram of how this is setup with the Brake Buddy.

view full answer...

Answer 8

If you wanted to be able to leave the #BB54FR attached to your tow vehicle without it possibly draining your tow vehicle's battery would be to add a switch like the part #D16740 on the red wire that runs to the charger so that you could cut off…

view full answer...

Answer 9

When it comes to choosing between the Blue Ox Patriot #BLU37TR and the Brake Buddy Select 3 #HM39524, these systems are extremely similar in their setup and functionality. Both of these systems provide proportional braking in a compact and easy to…

view full answer...

Answer 10

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 11

Hey there Jeff, thanks for the question and I can definitely get you all the parts needed to flat tow your 2014 Chevy Silverado 1500 behind your motorhome. I'll go ahead and list everything out for you to make it easy to order. - Base Plate Kit:…

view full answer...

Answer 12

Both the Roadmaster and Blue Ox tow bars are great options. But if it was my decision to make I would go with the Blue Ox Avail part #BX7420 as we have found that the Blue Ox tow bars are a little easier to connect and disconnect from. Also this tow…

view full answer...

Fuse Bypass Recommendation for a 2013 Honda CR-V for Flat Towing

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching