Tool used to Remove the Rivets that Hold the Taillight Assembly on a 2002 Dodge Grand Caravan
Question:
I have the hitch and trailer light wiring package ready to install on my 02 Dodge Grand Caravan Sport, but where do I get that handy-dandy little tool you used to pop the pushpins? Is there a substitute that I might have around the house to use that wont destroy the pushpins? Can I use a vice-grip? Thanks for your help.
asked by: Lil M
Expert Reply:
That handy-dandy tool you see in the videos is a trim panel tool. We have # PT73HJ as an option that you could use.
I advise against using vice grips as it will tear up the pins. You could use a smaller claw hammer if available. A very small pry bar (crow bar) could work as well. I suppose you could wedge two spoons under it and pry it out that way. Depending on how tight they are you might bend the spoons. If you had a very flat wrench it might work the same as the trim panel tool.
Products Referenced in This Question
Composite Trim Removal Tool Kit - 5 Piece
- Automotive Tools
- Fastening Tools
- Trim Removal Tool
- Nylon
- Performance Tool
more information >
Product Page this Question was Asked From
T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Converter
- Custom Fit
- 4 Flat
- Tekonsha
more information >
Featured Help Information
Instructions
Continue Researching
- Article: How to Install a Brake Controller on Chevrolet / GMC 1999-2006 Pickups
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Q&A: Replacement Motor for Lippert Model 1-065-041012-01 Landing Gear
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Brake Controller Installation: Starting from Scratch
- Q&A: How To Connect 4-Way Flat Vehicle Connector To 7-Way on Trailer
- Q&A: Recommended Trailer Wiring Harness For 2000 Toyota 4Runner
- Article: How Your RV Water System Works: A Complete Newbie's Guide
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Routing the Power Wire for a Trailer Wiring Harness
- Q&A: ST205/75r14 Trailer Tire Vs. a ST205/75D14
- Q&A: Installation of Roadmaster EZ5 Base Plate Kit RM-521567-5
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Q&A: Why Do Some Vehicles Need a Converter to Add Trailer Wiring Like a 2001 Chrysler Town & Country