Troubleshooting Trailer Blinkers that Both Blink at the Same Time
Question:
I have a trailer with electric brakes. I have running lights, brakes but when the turn signals are used both blinker come on at the same time. The wires are not crossed. I need help please..
asked by: Butch R
Expert Reply:
First thing you should do at this point is test the 4-way of the wiring harness with a circuit tester part # PTW2993 for voltage on all of the right pins when the taillight signals are being applied. Just like in the video I attached.
If the voltage checks out there but the trailer lights still don't function right then the problem is on the trailer wiring. That would mean that problem is either due to a ground issue or a short issue.
Make sure that the trailer side connector are clean and free of corrosion inside and out. The main connector grounds should be attached to clean and corrosion free bare metal surfaces. The light grounds should also be attached to clean and corrosion free bare metal surfaces. If there is anything between a light ground and the metal trailer frame or if the trailer has an aluminum frame, tilt bed, or folding tongue, any of these things can interrupt the ground. Running jumper wires from the light grounds to the main trailer connector ground can help.
If the problem is on the vehicle side then I would first recommend you double check how the harness is installed on your vehicle, make sure all of the connections are good and tight.
Products Referenced in This Question
Product Page this Question was Asked From
Tekonsha Push-To-Test Trailer Breakaway Kit with Built-In Battery Charger - Top Load
- Trailer Breakaway Kit
- Kit with Charger
- Top Load
- Single-axle
- Tandem-axle
- Triple-axle
- LED Tester
- Tekonsha
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Trailer Turn Signals Both Blink when Just Left Turn Signal is Activated
- Q&A: Troubleshooting Left Blinker Not Working on a Trailer
- Q&A: Trailer Turn Signals Both Blink at the Same Time When Right or Left Turn Signal is Turned On
- Q&A: All Trailer Lights Blink When One Turn Signal Is Activated
- Q&A: Troubleshooting Trailer Left Turn Signal Light That Does Not Blink
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: Trailer Wiring Diagrams
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Q&A: How To Choose Between a 1,000 Psi and 1,200 Psi Electric Over Hydraulic Actuator
- Article: Adding Electric Over Hydraulic Disc Brakes
- Q&A: What are the Dimensions of Replacement Trailer Hub Wheel Studs # RG03-080
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Choose the Right Trailer Hitch Class
- Article: Most Popular Wheel Bearings