How to Install a Tekonsha P3 Brake Controller in a 2000 Toyota Tundra

Question:

Hello I am in the market for a p3 brake controller. I have a 2000 toyota tundra and I understand the 2000 is not a plug and play system. What would I need to hook up the tekosha p3 brake controller. I do have a 7 pin plug already installed on the truck which was put on with the tow package. Any help is greatly appreciated. Thank you for your time.

asked by: Kevin

Helpful Expert Reply:

Since you have a 7-Way you will only need a few more components to complete a brake controller install on your vehicle.

First let's start with a brake controller. I would recommend the Prodigy P3 Brake Controller part # 90195. This is one of our best selling brake controllers because of how well it works and how easy it is to setup.

Next, for a wiring kit to install the brake controller and the 7-way adapter you would want the Wiring Kit for 2 and 4 Brake Electric Brake Controllers # 5506. This will provide the power source and ground for the wiring for the brake controller. You will need to test the wires from the brake pedal switch of your vehicle to find a circuit that has voltage when the brakes are applied and none when not applied. This will be the circuit you will run the red wire to.

Finally you will need to run a length of 10 gauge wire (part # 10-1-1) from the brake output circuit of the controller to the brake output circuit of the 7-way (blue wire). The # 10-1-1 is sold by the foot so you will need to order a quantity of the amount of feet you will need.

I attached an FAQ on installing brake controllers for you to check out.