Hitch Recommendation for a 2011 Ford Edge
Question:
Im looking to buy a trailer hitch for my Ford Edge. Which manufacturer would you recommend as having the highest quality of hitch? I want one that wont rust like my last one. Thanks.
asked by: Steve
Expert Reply:
I would recommend the Draw-Tite part # 75992. This hitch has an e-coat base and is powder-coated on top of that for superior rust prevention over other hitches that only have powder-coating.
This hitch is also a Class III 2 inch hitch that will give you more towing capacities and accessory options than a 1-1/4 inch hitch.
I attached an install video for you to check out as well.
If you plan on doing some towing you might be interested in etrailer ball mount kit # 989900. It comes with 2 ball mounts; one with a 3/4 inch rise or 2 inch drop and one with a 2-3/4 inch rise or 4 inch drop. It also includes a 1-7/8 inch ball, 2 inch ball, hitch pin with clip, and a storage bag.
If the ball mount kit does not have the right rise or drop to tow the trailer level, use the link I have included that explains how to measure to choose a ball mount to tow the trailer level.
For trailer wiring you would want the part # 118515. I attached an install video for you to check out as well.
Products Referenced in This Question
T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Powered Converter
- Custom Fit
- 4 Flat
- Tekonsha
more information >
etrailer Ball Mount Kit for 2" Hitches - 7,500 lbs
- Trailer Hitch Ball Mount
- Fixed Ball Mount
- 1-7/8 Inch Ball
- 2 Inch Ball
- Two Balls
- Steel Ball
- Steel Shank - Gloss Black
- Drop - 2 Inch
- Drop - 4 Inch
- Rise - 1 Inch
- Rise - 3 Inch
- Fits 2 Inch Hitch
- 7500 lbs GTW
- Class III
- Ball Mount Kit
- etrailer
more information >
Product Page this Question was Asked From
Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class III
- 400 lbs TW
- 4000 lbs GTW
- 4000 lbs WD GTW
- 2 Inch Hitch
- 400 lbs WD TW
- Concealed Cross Tube
- Draw-Tite
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Wheel To Replace Discontinued Lionshead Black Tiger Wheel for Camper
- Q&A: I A Latch For My RV Door That Has A 4-1/2 inch X 4-1/2 inch Hole
- Q&A: Recommended Replacement Grease Seal for 2014 Shorelander Boat Trailer
- Q&A: Trailer Hitch Receiver and 4-Way Flat Vehicle Wiring Harness For a 2024 Ford Maverick
- Q&A: Does the Ventline Exterior Wall Vent for RV Range Hood # V2018-01 Have a Screen
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Why Is a 10" Lube Plate Recommended for a B&W Companion Instead of 12"
- Article: My Trailer Hitch Doesn't Fit
- Article: How to Correct Noise from Exhaust Rattling Against a Trailer Hitch
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Best Bike Racks for Fat Bikes
- Article: How to Choose a Bike Rack for an SUV or Crossover