How Difficult is Trailer Hitch and T-One Wiring Harness Install on a 2007 Dodge Nitro
Question:
I want to purchase the Curt 13334 hitch for my 07 dodge nirto and would like to know if the bumper needs to be cut out to make this hitch fit also how much trouble is it to install the 118554 wire harness. please respond asap want to order thanks
asked by: Dale H
Expert Reply:
According to the instructions, the bumper cover or rear fascia does not need to be cut or trimmed and there is no drilling required. I have added a link to the instructions for the hitch below. The 4-Way trailer harness for your 2007 Dodge Nitro, part # 118554, is not difficult to install. In a nutshell, all you will need to do is temporarily remove the tail lights, connect the harness to the tail light connectors and put the tail light lights back in place. Again, I have added a link to the instructions below for the trailer harness that will walk you through the procedure.
Anyone with basic tools and basic mechanical skill set should be able to install both of these items.
Products Referenced in This Question
T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Powered Converter
- Custom Fit
- 4 Flat
- Tekonsha
more information >
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class III
- 350 lbs TW
- 3500 lbs GTW
- 5000 lbs WD GTW
- 2 Inch Hitch
- 500 lbs WD TW
- Visible Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: My Trailer Hitch Doesn't Fit
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: How to Determine if Reese Elite RE25 Will Fit with 2019 Ford F-350 with Higher Bed Side Walls
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Compatibility of Pickup Truck Ladder Racks with Tonneau Covers
- Article: Routing the Power Wire for a Trailer Wiring Harness
- Q&A: Brake Controller and 7-Way Harness for 2011 Dodge Nitro
- Article: Brake Controller Installation: Starting from Scratch
- Q&A: Can Curt Echo Mobile Brake Controller Be Used While Trailer Battery is Charging
- Q&A: 4-Way to 7-Way Adapter Recommendation for Installing Curt Echo Brake Controller
- Q&A: Does Curt Echo Allow 12V Power to Pass to Trailer Battery
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: Rooftop Cargo Carriers