Amperage Draw of the Kats Heaters Vehicle Heaters # KH11813

Question

Question:

What is the electrical usage for this product? I live in an apartment complex and there are no outlets in our parking lot, so I was considering purchasing a portable power supply, but need to know how much current this will pull to be sure I get one that can handle the load. Thanks!

asked by: Sarah W

0

Expert Reply:

The Kats Heaters Vehicle Heaters # KH11813 is rated for 400 watts. To convert watts to amp you divide the watts by the volts.

Since this gets used with 120 volts the amperage draw is 3.33 amps

expert reply by: Jameson C

0

Answer 1

Kat's does recommend coating the cartridge with NSCG silicone grease G-624 before inserting the cartridge heaters like the #KH11813 into the block.

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 5

For your 2018 Toyota RAV4 with the 2.5L I4 engine the Kat's Heaters Custom Fit Engine Block Heater #KH11813 will work perfectly. This cartridge heater will clip right into the cavity of your engine block and submerges in the coolant to keep them…

view full answer...

Answer 6

According to Rhino Rack, if you were to go with the shorter bars, you'll only have 1-1/4 inch of leeway on each side which isn't enough in their opinion. I'd recommend going with the 71 inch bars so you'll be certain of a good fit. As…

view full answer...

Answer 7

Yakima's Skyline towers part #Y53TR can fit the tracks of the Retrax XR that you have with the landing pad 1 part #Y00221 but there isn't a way with the Baseline towers. Your Yakima Corebar or Jetstream bars will work with the Skyline towers…

view full answer...

Answer 8

Hey Tami, so since your 2021 Toyota Highlander has the flush mount rails, your only option for adding a cargo basket will be to first add a roof rack with crossbars. I suggest going with a Rhino Rack Aero Bar roof rack, which will consist of the…

view full answer...

Answer 9

What I would do is go out to your truck and measure out 71 inches and 65 inches on a tape measure and compare that to the width of your bed. If you think the 71 inch looks better and would suit your needs then that's what you would want to go…

view full answer...

Amperage Draw of the Kats Heaters Vehicle Heaters # KH11813

Product Page this Question was Asked From

Continue Researching