Mounting Post Measurements On Westin Replacement Step Pads For Westin Oval Tube Steps

Question

Question:

HI I WAS WONDERING IF YOU CAN SEND ME THE MEASUREMENTS ON THE MOUNTING POSTS ON THE BOTTOM OF REPLACEMENT PAD, FROM CENTER TO POSTS, THEY LOOK LIKE THEY MIGHT REPLACE THE MISSING ONES ON MY FACTORY OEM STEPS ON 2003 FORD F350. THANKS GUS

asked by: GUS

0

Expert Reply:

I pulled one of the Replacement Step Pads For Westin Oval Tube Steps, part # 22-5001 and took some measurements for you. As the attached photo shows, the pad has 7 posts that are staggered for mounting. The positions of the posts are noted on the photo so you can see if they will work for you.

This is a non-slip polymer plastic pad that measures 26 inches x 4 inches overall. For the installation in the Westin tube step, it does require 7 barrel clips, part # 23-0002.

expert reply by: Jeffrey L

0

click to enlarge

Answer 1

The closest replacement step bar pad we have to those measurements is the Replacement Step Pad for Westin Oval Slimline Tube Steps #80-0231. The Replacement Step Pad for Westin Oval Slimline Tube Steps #80-0231 measures 25-3/4" long and…

view full answer...

Answer 2

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion…

view full answer...

Answer 3

It sounds like the purpose of getting the air helper spring would be to counteract the 1 inch compression you're getting in your rear suspension caused by the pin weight of your 5th wheel. If that's the case, I believe that the…

view full answer...

Answer 4

The outer diameter of the upper tube of the Andersen Ultimate Offset part #AM3140 is 4 inches.

view full answer...

Answer 5

I spoke with my contact at Trailair and from your serial number we were able to determine that your trailer came with a 1621 HD pin box which is a long pin box style. I was unable to obtain the exact part number for your Trailair pin box but from the…

view full answer...

Answer 6

If you can't find the brand of step that you've got and you're looking for a replacement pad, then yes; the number of post holes and the spacing between them is going to be a good reference point to determine which nerf bars you've…

view full answer...

Answer 7

When installing the rocker switch wiring harness, you need to use a wire that goes hot when the ignition switch is turned on. On my Polaris I used the wire that came from the accessory (cigarette lighter) plug because it is only hot when the key is…

view full answer...

Answer 8

The Replacement Step Pad for Aries 4" Wide Oval Nerf Bars #AA2090133 are longer than the ones that you currently have. The overall length is 23-5/8" long. The center 2 pegs are 12-5/8" apart on center and the outer pegs are another…

view full answer...

Answer 9

Thank you for those dimensions, and I think we may have what you need for your Tacoma with the following part: - Replacement Step Pad for Westin Platinum Series Oval Nerf Bars #21-0001 I have added a photo with the measurements of this replacement…

view full answer...

Answer 10

Actually, if you look closely the #AA2090161 has 4 pegs and a center pin used to align the step. Aries tells me that the #AA2090161 is indeed the proper replacement step for their 4 inch wide oval step bars. I've provided a photo showing the…

view full answer...

Answer 11

We do indeed offer replacement step pads. There are two possible replacement pads for the Aries Automotive #AAS224046-2 step pads. You an look on the bottom of the pad that came loose and you'll immediately be able to determine which one you…

view full answer...

Mounting Post Measurements On Westin Replacement Step Pads For Westin Oval Tube Steps

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching