How to Trailer Suspension Hangers Get Installed on a Trailer Frame
Question:
how do you mount new hangars? do they have to be welded or bolted to frame? I saw in the video hangars had 2 holes in top of hangar.
asked by: Jimmy
0
Expert Reply:
To install trailer suspension hangers like what come in the Tandem-Axle Trailer Hanger Kit # APT5 that you referenced you will want to have them welded on professionally by a qualified welder.
I attached a review video for this kit as well as an FAQ on trailer suspension for you to check out.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Tandem-Axle Trailer Hanger Kit for Double Eye Springs - 3-1/4" Tall Front/Center/Rear
- Trailer Leaf Spring Suspension
- Hangers
- Suspension Kits
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Double Eye Springs
- Tandem Axle
- etrailer
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: What Causes Shackle Straps To Flip Below the Equalizer
- Q&A: Determining Spring Hanger Spacing for Tandem Axle Trailer Fabrication Project
- Q&A: How to Determine Hanger Spacing for Tandem Axle Trailer Suspension with 26 Inch Springs
- Q&A: Tandem Axle Trailer Suspension System Dimensions for Best Function
- Article: Double-Eye Trailer Suspension System Review
- Article: Most Popular Wheel Bearings
- Article: Where to Position the Trailer Axle?
- Article: Trailer Wiring Diagrams
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: How to Accurately Measure Trailer Leaf Springs
- Q&A: How to Determine Hanger Spacing on a Tandem Axle Trailer
- Q&A: Installation of Hanger Brackets and Springs for Tandem Trailer Axles
- Q&A: Why is Center Hanger Longer for Tandem Axle Trailer Hanger Kit
- Article: Trailer Tire Sizing