How to Make the Wiring Connections of the Replacement Switch # LG-145236
Question:
What type of ends nedd put on the bear ends of the replacement wiring? Thanks
asked by: Tom
0
Expert Reply:
To make the wire connections to install the Replacement Switch # LG-145236 that you referenced you have a few options. The most recommended method would be to solder the connections and then wrap the connections with electrical tape.
Next we have butt end connectors like the # 05731-5. Finally, some use twist connectors which we don't carry. They aren't recommended so I wouldn't use them anyway but I figured I'd give you all the options that are out there.
expert reply by:
Jameson C
0
Products Referenced in This Question
16-14 Gauge Butt Connector - 5 Pack
- Wiring
- Wire Connectors
- Butt Connectors
- 16-14 Gauge
- Deka
more information >
Product Page this Question was Asked From
Replacement Switch for Stromberg Carlson Electric Landing Gear
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Switches
- Stromberg Carlson
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Replacement Fulton Winch Strap Measuring 1-7/8 Inches by 14 Feet Long
- Q&A: Tire and Wheel Size to Replace 18.5x8.5-8 on Trailer
- Q&A: Towing a Trailer with Electric Brakes with a Semi Tractor with Air Brakes
- Q&A: Replacement for Atwood 70254 RV Landing Gear Switch
- Q&A: Parts Needed To Install Solera Awning Fabric On Slide-Out
- Q&A: What Does Hole In Rear Hanger For 2-1/2" Wide Hanger Used For?
- Q&A: How To Find the Correct Replacement Switch for a Landing Gear Set
- Article: How to Charge RV Batteries
- Article: How to Use a Roof Rack (Like a Boss)
- Article: Trailer Wiring Diagrams
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: What Size Generator Do You Need to Run an RV Air Conditioner?
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: Adapters for Towing a 5th Wheel Trailer with a Gooseneck Hitch