Videos
for Tool Organizer
Help Articles
for Tool Organizer
Expert Answers
for Tool Organizer
Both the LED Trailer Mini Clearance #MCL10AKB and Uni-Lite LED Clearance #MCL11RKB will require an 11/16" hole for mounting. These both use the same Grommet #A11GB.
view full answer...Erickson has the spacing for the mounting holes of the #EM09160 before and after the chock at approximately 4-3/8" center to center. Since they unfortunately do not offer a custom backing plate the #e96RR you purchased is going to be…
view full answer...It looks like you have the BAKFlip MX4 for the 2013 Ford F-350 short bed, part #BAK48310. This tonneau cover does install inside the bed rails, so using the Thule TracRac SR Sliding Truck Bed Ladder Rack that is compatible with your truck, part…
view full answer...For your 2015 Ford F-250, the BAKFlip folding hard tonneau covers will work well and there are 4 options to choose from. There is the BAKFlip G2 Hard Tonneau Cover #BAK26310, FiberMax #BAK126310, F1 #BAK72310, or MX4 #BAK48310. Each of these…
view full answer...Yes, you can use the camera from your 4.3" monitor with the Replacement 7" Monitor for Furrion Vision S Wireless RV Camera System part #FR47FR, just go through the pairing process and you're good to go.
view full answer...To add two side cameras to your Furrion Vision S Wireless RV Backup Camera System with 5" Screen #FOS05TASF, you can use the Marker Light RV Side Cameras #FCE48TASL. I can understand your concern with the trailer having all LED lights, but…
view full answer...Yes you can upgrade the 5 inch monitor of your Furrion Vision S system with a 7 inch one with the part #FR47FR and you'd be set.
view full answer...Yes, you can upgrade the 4.3 inch monitor of your Furrion setup to the 7 inch #FR47FR or the #FR97FR for the 5 inch. This will work great and give you an easy to view monitor.
view full answer...You can upgrade your monitor to the 7 inch version with part #FR47FR. Your power cable can be reused but you'll need a new mount #FR79SR.
view full answer...The Replacement 7 inch monitor you'd looked at, part #FR47FR (which is Furrion's part #FOS07TAPK-008 is indeed a correct replacement for your original monitor. According to Furrion, it will be compatible with your existing system, as…
view full answer...I went to our warehouse to measure the Draw-Tite Ball Mount #2753 for the dimension you asked for. Please refer to the linked photo I prepared for you.
view full answer...When our installers replace a trailer hub, there isn't a set torque spec used when tightening the spindle nut. The hub is placed on the spindle, making sure the inner and outer bearings are correctly seated. The spindle nut is then run down…
view full answer...