Filter Results
$89.99 - $89.99
$74.97 - $89.97
$62.98 - $89.99
Videos
for Gas Can
Help Articles
for Gas Can
Expert Answers
for Gas Can
I checked with Erickson and their Removable Motorcycle Wheel Chock item #EM07506 does not have a weight rating. It is made of steel and works with bikes that have up to 6" tires. So long as your Honda and Kawasaki do not have wider tires…
view full answer...According to Maxtrax, the mounting holes on the #MA24ZV are 10" on center across the width of the board and 25" lengthwise. All of the mounting pins like #MA48PR use M10 bolts so you will need to drill an appropriate hole based on…
view full answer...Thanks for the pictures! Since your 2022 Grand Design Reflection 303RLS came with the CRE3000 equalizers you will need three of the MORryde X-Factor Crossmember item #MR33WR. It looks like you have the standard 3" wide frame hanger so all of…
view full answer...The Front Runner Slimline II Platform Rack #FR89MJ is the best way to carry a Tent #FR26RV on your 2024 Kia Sportage. The platform will attach to your raised roof rails and will allow you to attach the tent using their Kit #FR99RV.
view full answer...The Dexter Trailer Hub and Drum Assembly #K08-201-9B that you referenced has a stud length of 1-1/4 inches which is the standard length for trailer hubs like yours.
view full answer...To replace the batteries of the TPMS Cap sensors included with the TST TPMS for RVs - Color Display - Signal Booster - 6 Tire Sensors #TST-507-RV-6-C you will need to use the included wrench to turn the nut on the sensor counter clockwise. That…
view full answer...The Traffic Cone Holder, #RA-26, that you mentioned is designed to store cones that are 12" - 36" tall, and the arm of the holder is 22-3/8" long. The arm does not fold down a full 90 degrees, so this would not be the best…
view full answer...Yes, I was able to verify with Curt their Front Mount Trailer Hitch Receiver #C31078 will fit your 2024 Ford F-250 4 wheel drive.
view full answer...Yes, the Timken Bearing Kit #TMK52VR will fit your 3,500 lb axle as it fits an standard #84 spindle. The only time this kit won't fit with a 3,500 lb axle is if the trailer/axle is made before the 2000's since that's about the time that…
view full answer...You can use the Thule Insta-Gator Pro #TH93VR and GateMate Pro #TH824PRO with the TruXedo Sentry CT Hard Tonneau Cover #TX1573316 installed on your 2021 GMC Sierra 2500 6-3/4' bed. If you just need to transport 1 bike then the Insta-Gator is my…
view full answer...Any scuffing of either of these tonneau covers, The Truxedo Sentry or the Truxedo Sentry CT will probably be permanent. I think it will be harder to see those imperfections on the Sentry CT because it's cover is a woven 5-layer fabric, which…
view full answer...Yes! Make sure to have the bow and stern tie-downs included with the Yakima JayLow #Y04073 properly secured to the front and rear of your vehicle and you're good to go! If you're carrying a second kayak, you will need another set of bow/stern…
view full answer...