Depends on the condition of the wood but the backing plate of the Brophy D-Ring Tie Down Anchor w Backing Plate # RR5K that you referenced is designed to distribute the weight so that it does not easily rip through the wood.
I attached a picture of what the backing plate looks like installed. If the floor is strong enough for the weight of your snowmobile it's going to be strong enough for the backing plate to be effective. view full answer...
The Superwinch LT2000 winch has a 50 foot long wire rope with a 5/32 inch diameter so for a replacement the best I can currently offer is the # FWC7500100 which is 7/32 and 50 foot and you'd be set. There's no way to convert the winch to a synthetic rope.
I attached a picture that covers how the replacement is done as well. view full answer...
We do have a winch mount for your 2007 Yamaha Wolverine 450 4x4. It is # BDW15140.
We do not have a hitch mount for your Wolverine though. view full answer...
Yes, the smaller side lens does come with the Replacement Tail Light and Side Marker Lens for Optronics Combination Tail Light # A16RB that you referenced. view full answer...
You could use a universal style of trailer wiring for your 2018 Yamaha Viking like the Tekonsha part # 119190KIT which would splice into the taillight circuits of the Vikings to provide the trailer lighting. view full answer...
A 23 inch diameter motorcycle tire would not be an issue at all for the Rack'Em Manufacturing Removable Wheel Chock # RA-17 that you referenced. As long as the tire is less than 6-1/2 inches in width this will fit and work well. view full answer...
What you'll need to do is measure your current springs without the weight of the trailer on them and we'll be able to set you up with the springs you'd need. We most likely have a fit that would work well but here are the options we have:
# e54SR which is 25-1/8 inches long
# SP-210275 which is 27 inches long
# e59SR which is 23-1/8 inches long view full answer...
For your 2006 Yamaha Wolverine 450 we have the custom mount # BDW15140 which mounts directly to your vehicle frame. This mount is also compatible with the Superwinch LT3000, # SW1130220, that you have referenced and the combination will work very well for you. view full answer...
The Dexter trailer axle # 84545UC1-EZ that you mentioned is sold individually. If you needed two you would need to order a quantity of two. view full answer...
The Taskmaster Wheel and Tire Combo 4.80-12 part # AM30660 that you referenced has a 90 psi max rating. You'd want to inflate them to 90 psi when cold and you'd be set. 100 psi would be too much. view full answer...
Did you extend it to the point where the jack stopped moving but the motor was still making noise? If so, you over extended the jack and damaged the nut and screw. Unfortunately this jack does not stop automatically when it's topped out which will allow it to over extend and damage itself.
You'll have to replace the jack.
I think the best value for an A-frame tongue jack is the Stromberg Carlson # SC63VR which is rated for 4500 pounds of tongue weight. This is 1000 pounds more than other... view full answer...