I checked with Yakima and the replacement brackets alone - without the hardware - is not available as a replacement part. So you will get the brackets and the hardware when ordering the Replacement Mounting Brackets for Yakima RoadShower # Y8881255.
We can't remove pieces of a kit and retroactively apply a discount, you'll need to get the brackets with the hardware. view full answer...
The Draw-Tite Class III 2 Inch Trailer Hitch, # 75684, that fits your 2010 Hyundai Santa Fe will include the complete mounting hardware kit and installation instructions.
If you are towing you will also need the Curt Ball Mount, # C45010, and the Pin And Clip, # PC3. The recommended hitch ball would be the Tow Ready 2 Inch Hitch Ball, # 19247.
The wiring harness you will need is the Tow Ready T-One Wiring Harness, # 118415. If you have the factory tow package you would use the Draw-Tite... view full answer...
Wiring and hitches are sold separately because not everyone uses a hitch for towing. Trailer hitches for the 2011 Hyundai Veracruz such as # 75532 include the hitch and the hardware to install it.
For the trailer wiring you can use harness # C56332 to add a 4-Way flat connector to the rear of the vehicle.
I also recommend etrailer ball mount kit # 989900. It comes with 2 ball mounts; one with a 3/4 inch rise or 2 inch drop and one with a 2-3/4 inch rise or 4 inch drop. It also includes... view full answer...
The K-Source Replacement Side Mirror # KS65033Y does carry the heat, power remote, and turn signal functions but it doesn't have the lane warning function. I confirmed this with my contact at K-Source.
I also checked to see if any of the other replacement mirrors have that lane warning function and they don't so this is your best option as it carries everything else you're looking for. view full answer...
The ball mount that comes with Hidden Hitch trailer hitch # 60301 (no longer available) for your 2016 Hyundai Accent hatchback is # 3592. On a Class I trailer hitch like this you have to use the ball mount specified by the hitch manufacturer or it voids the hitch warranty. The ball mount must be used in the rise position only.
For a 1-7/8 inch ball use # 19256 and for a 2 inch ball use # 19258. And for trailer wiring use # C56254. Please note that the vehicle owner's manual states that... view full answer...
Advent Air Rooftop RV Air Conditioner # ACM135B is just the outside part of the air conditioner. For the inside, ceiling portion you could use # ACDB. view full answer...
Yes, the Curt Trailer Hitch Receiver # C23WR does include the 6 bolts and washers for attaching to your 2023 Hyundai Santa Cruz.
I recommend installing the Vehicle Wiring Harness # CU94FR when you install the receiver. This will control the tail lights on most small trailer with a 4-way flat connector. It will also allow you to use Auxiliary Lights # C53201 if you have a hitch mounted accessory which impairs the view of your tail lights. view full answer...
The # PWH2219SC Glacier Twist Link Snow Tire Chains include a heavy fabric carrying bag. The chains are a confirmed fit for the # 235/55-19 tire size. I've linked you to some FAQ articles about tire chains that you might find helpful. view full answer...
The Replacement Namsco Wheel Cover - 19-1/2", 10-Lug Wheels # NA7195B3 does come with the center cap attached. It is really difficult to see due to the reflection on it. I attached a video that will help you see the center cap on the cover.
If this is not what you meant, please feel free to respond to this answer and I will give you further assistance. view full answer...
You assume correctly, the Pewag Servo # PWRS69 chains are sold in pairs. Before purchasing or installing chains, please check your owner's manual to see if Hyundai has any specific recommendations about using tire chains.
Once you get the chains, it's a good idea to do a dry run or two so that when the time comes, you'll know how to install them. I'd rather you learn in your garage or on your driveway than when you're up to your ears in a snow drift.
I've linked you to our FAQ article... view full answer...
Purchasing a hitch for your 2021 Hyundai Kona EV such as the Draw-Tite # DT52GR Class 3 hitch will indeed include all necessary installation hardware and printed instructions, which I've linked for you. view full answer...
All you need for attaching a brake controller to your 2022 Hyundai Palisade is the receiving-end setup.
For that setup, you need to have a 4-way and a 7-way wiring harness in order to use a brake controller. If you do not have the 4-way installed already, I recommend the Curt T-Connector Vehicle Wiring Harness # CU94FR. The T-Connector includes a powered converter to ensure that your vehicle's wiring matches that of your trailer. Once you install the 4-way (or if you already have one),... view full answer...
The Curt hitch part # C13152 that you referenced comes with 4 carriage bolts 1/2-13 x 4 1/2, 4 flange nuts HFN 1213, GR8, 4 hex bolts M10 - 1.25 x 25 and four 3/8 inch conical toothed washers. Plus a 11GA. (.1196) SPACER PLATE.
We sell the replacement hardware for this hitch (and all of the hitches we carry) as part # RHK. view full answer...
Yes, the Swagman Trailhead 2 Bike Rack, # S63360, comes with an anti-rattle, threaded hitch pin and clip which will secure the rack to your trailer hitch.
I have attached a short video for you. view full answer...
The Curt Class I 1-1/4 Inch Hitch for the 2005 Elantra by Hyundai, item # C11220, comes with all of the hardware and installation instructions needed to install the hitch on your vehicle.
Some items you may need to complete your Class I towing setup are listed below.
Drawbar # 3593
Hitch Ball 1-7/8 inch, item # 19256
Hitch Ball 2 inch, item # 19258
Wiring # 119178KIT view full answer...
According to Putco, there are four total lights included. Two of those lights install in front, also called the map lights, and the other two install as dome lights.
I have linked the a video showing installation in the map light area, and the installation instructions for you. view full answer...
The Tuson DirecLink Base Model Trailer Brake Controller part # 335DL-100 and Tuson DirecLink Lite Trailer Brake Controller part # 335DL-50 are both great brake controller options.
The best option for you will be dependent on where you will be doing most of your driving. If you find yourself frequently traveling though town in stop and go traffic then the base model which has the low speed brake adjustment feature would be a really good option but not necessarily required. If you are driving... view full answer...
Yes, the Curt Trailer Hitch Receiver # C11529 comes with the fishwire needed to install this on your 2018 Hyundai Kona. I have attached a picture of the included hardware for you to reference.
If you let me know what you will be using this trailer hitch for I can make additional recommendations as necessary. view full answer...
Hidden Hitch, item # 60816 (no longer available), comes with drawbar, item # 3592. This drawbar has a 2-1/8 inch rise and is to be used in the rise position only on your vehicle see instructions. Class 1 hitches are factory tested for safety and the recommended drawbar is the only drawbar that should be used for that vehicle, in the position recommended. view full answer...