The Hott Rod RV Water Heater Conversion Kit # DGR10VP is much too powerful for a 6 gallon water heater, and is meant for use with a 10 gallon water heater. Instead, you'll want to use the Hott Rod RV Water Heater Conversion Kit # DGR6VP. view full answer...
The Camco RV Water Heater Anode Rod for a Suburban water heater is part # CAM11563. This anode rod measures 3/4 inches in diameter and is 9-1/2 inches long.
The Camco RV Water Heater Anode Rod, # CAM11593, that you referenced was designed for the 10-gallon Atwood heater and measures 1/2 inches in diameter and is 9-1/2 inches long. view full answer...
Yes it is; for a 6-gallon tanked RV water heater, there isn't a better option than the Dometic:
- Dometic RV Water Heater - Gas and Electric # DMC74FR
At 10,000 Btus, this water heater has a higher heating capacity than other units for better overall efficiency, and it is a gas and electric unit that an automatic pilot as opposed to a manual pilot, making it the most convenient option.
The only other thing to keep in mind is the cut out that the Dometic RV Water Heater # DMC74FR fits,... view full answer...
While we do not really deal with Park models and I had a hard time finding information, from what I could find, it looks like they typically use water heater models that are often times found in RV's.
If you have an RV style water heater and wiring in place and have the room to fit the Furrion RV Tankless Water Heater # FR93FR (12-5/8" wide x 12-5/8" tall x 19-1/4" deep) then you can use it.
You may want an access door to compete the installation, there are multiple sizes available.
-... view full answer...
The correct Hott Rod RV Water Heater Conversion Kit for a 6 gallon water heater is part # DGR6VP, the part # DGR10VP is for 10 gallon water heaters and would be too powerful for a 6 gallon. view full answer...
The Foggati tankless water heaters are 100 percent going to be an upgrade over a standard water heater due to their efficiency, as it only uses energy when you turn on the hot water instead of a standard heater that is always using up energy to keep the water hot.
And while it is very likely to fit, we don't have any way of knowing fits of a heater in any specific trailer, so you'll just need to take some measurements for either of the Fogatti heaters, which are the following part numbers:
-... view full answer...
The Furrion RV Tankless Water Heater # FR98SR is indeed 12 volt only and cannot be used with 120 volt AC power. The only 120 volt powered water heater is from Dometic, the Dometic RV Water Heater - Gas and Electric # DMC74FR. view full answer...
Your gh6-7e water heater is a 6 gallon water heater so for a replacement the Dometic RV Water Heater # DMC74FR that you referenced would be a great replacement solution as it is the same size. view full answer...
Yes, the Camco RV Universal Gas Water Heater and Furnace Thermocouple # CAM09253 that you referenced does fit the Atwood RV Water Heaters like the # AT96161SU which is similar to what you referenced. view full answer...
I spoke with Camco and they informed me that the Camco RV Water Heater Thermostat part # CAM08143 will work with the Camco Propane to Electricity Converter for 6-Gallon RV Water Heaters part # CAM11673 that you referenced. view full answer...
We don't have any way of knowing what anode rod is needed for a water heater in any specific trailer. If you have a Suburban (Mor-Flo) heater use the Camco RV Water Heater Anode Rod # CAM11563; for an Atwood water heater use the Camco RV Water Heater Anode Rod # CAM11553. view full answer...
The Camco RV Water Heater Anode Rod # CAM11533 that you referenced can be used with a bushing for your Suburban water heater. My contact at Camco confirmed this.
When I spoke with my contact at Camco he did say that if your Suburban water heater is a 10 gallon then you would be better off to go with the Camco RV Water Heater Anode Rod # CAM11563 instead which already has a 3/4" diameter. view full answer...
All data needed for the Wall Controller for Furrion RV Water Heaters # FR48NR to communicate with the Furrion RV Tankless Water Heater # FR93FR is transferred with the two blue wires along with the power for the controller. view full answer...
The Dometic RV Water Heater # DMC74FR can replace your Atwood G6A-8E but it is quite a bit smaller so you'll need to use the Water Heater Door Conversion Kit for 6 Gallon Electric and Gas Water Heater # DMC84FR to fill in the gap left behind. view full answer...
The correct replacement water heater for your GC6AA-8 water heater is the Atwood RV Water Heater Item # AT96117. This water is heater is an exact replacement. view full answer...
The Furrion RV Tankless Water Heater part # FR98SR is the same size as the Dometic RV Water Heater part # DMC74FR (WH-6GEA) so there will be no issues with replacement. This however is a gas only unit so there will be no electric hookups. view full answer...
We don't offer Aqua-Pro so haven't heard anything about them and don't have any experience with how they work or fit. There are magnesium water heater anode rods we know for certain work with Atwood water heaters, which are the following:
- Camco RV Water Heater Anode Rod - Magnesium - 1/2" Diameter x 4-1/2" Long # CAM11553
or
- (10 Gallon Atwood Water Heater only): Camco RV Water Heater Anode Rod - Magnesium - 1/2" Diameter x 9-1/2" Long # CAM11593 view full answer...
The Hott Rod RV Water Heater Conversion Kit # DGR6VP will fit your Atwood LP gas hot water heater assuming you have a 6 gallon tank. It is designed to fit a variety of water heaters with 6 gallon tanks, including Atwood. This kit will achieve what you are wanting to do, converting the hot water heater from propane to electric operation while keeping the LP system intact. It will install into the drain plug with a threaded adapter and comes with an adjustable thermostat.
I have attached... view full answer...
We do have a water heater that you can use as a replacement for your Atwood GC6AA-10E, but this particular water heater has been discontinued, so you'd need a different option. You'll just need to ensure the heater fits in the same cut out as the 12-1/2" tall x 16" wide x 18" deep Atwood, and the best option for that is from Fogatti, which fits a 13" tall x 13" wide x 17-3/4" deep cut out.
These are actually tankless water heaters, which are a huge improvement over the standard heaters... view full answer...
When using the Furrion RV Tankless Water Heater # FR93FR, there is not a door conversation kit. There are just 3 different door sizes to choose from.
- Replacement Access Door for Furrion RV Tankless Water Heater # FR43FR (16" x 16")
- Replacement Access Door for Furrion RV Tankless Water Heater # FR63FR (16" x 18")
- Replacement Access Door for Furrion RV Tankless Water Heater # FR73FR (18" x 18")
It looks like your current Atwood GC6AA-10E requires a 12-5/8" tall and 16-1/4" wide cut-out.... view full answer...