Expert Answers about Toyota Camry
- How Far Apart Should the Bolt Holes to Mount a Hitch on a 2013 Toyota Camry Be
- Your best bet is going to be to confirm the part number on the spec sticker of the hitch; the Draw-Tite # 36540 and Curt # C12107 are the confirmed hitches we offer for your 2013 Toyota Camry. The distance between the bolt holes on these hitches are all different depending on their positions but they are:
38" apart center on center for holes closest to engine
38-1/4" apart center on center for holes closest to bumper
37-1/4" apart center on center for the middle holes
I've also linked...
view full answer... - Width of the Hook on the UWS Replacement Twist Latch # UWSTWISTLOCK
- I went out into our warehouse and measure the width of the hook on the UWS Replacement Twist Latch # UWSTWISTLOCK and found it to be 11/16 inches wide.
view full answer... - Can a 2 Inch Trailer Hitch Mount Accessory be Used on a 1-1/4 Inch Hitch on a 2011 Toyota Camry
- It is possible to use your 2 inch accessories in a class II, 1-1/4 inch trailer hitch. You would have to use a hitch expander, 1-1/4 to 2 inch. However, the use of an expander will reduce the tongue weight capacity of the trailer hitch by 50 percent.
It appears that the vast majority of trailer hitches for a 2011 Toyota Camry have a tongue weight capacity of 300 pounds. When using an expander, like # 80303, that capacity will be cut down to 150 pounds. This means that the weight of any...
view full answer... - Can Rhino Rack 2500 Series Roof Rack Carry 16 ft Canoe on 2009 Toyota Camry
- Depending on its weight, the rack you asked about might very well be able to handle your canoe.
The Rhino Rack 2500 Series roof rack for your 2009 Camry, which consists of parts # RRVA118B-2, # RRRLKVA, and # DK114 which is the vehicle specific clamp kit that attaches the crossbar/leg assembly to your Camry. When assembled, the crossbar/leg/clamp assembly has a 130 lb weight capacity.
However, this capacity might be limited by the weight bearing capacity of your Camry roof, if it is lower....
view full answer... - What are the Dimensions of Replacement Thrust Bearing, # BD500223 For Bulldog Trailer Jacks
- I spoke with my contact at Bulldog about the Replacement Thrust Bearing, # BD500223. He stated that the bearing has an inner diameter of approximately 0.525 inches, and outer diameter of 1.25 inches, and it is 0.43 inches thick.
view full answer... - Recommended Hitch and Wiring Harness for a 2023 Toyota Camry
- The only hitch available for a 2023 Toyota Camry is the Curt Trailer Hitch item # C11576. This hitch is custom fit and bolts to your Camry with included hardware. The pricing will be on the right side of the product page.
This is a class II hitch with a 2,000 lbs towing capacity and a 200 lbs tongue weight. It looks like the towing capacity for your car goes up to 2,000 lbs depending on the model. You will want to verify what your model's actual capacity is and make sure your camper doesn't...
view full answer... - Why Is There Hitch for 2015 Toyota Camry If it is Not Rated for Towing
- We can verify that the Draw Tite hitch part # 36540 that fits your 2015 Toyota Camry has the towing capacities of 3,500 lb trailer weight and 350 lb tongue weight but as far as the vehicle you'd have to go with what a Toyota dealer or your manual states. We do have quite a few hitches for vehicles that technically are not rated for towing and how that happens is that if there's a demand for a hitch to be made for a vehicle our manufacturers will make it as there are plenty of people who...
view full answer... - How Much Weight Will the Curt Roof Mount Cargo Basket Support
- The weight capacity of the Curt Roof Cargo Carrier, # C18115, is 150 pounds. But if the roof or roof rack is rated lower it is limited to the lower capacity. You will need to consult the vehicle owners manual for your 2009 Toyota Camry Hybrid for the roof and rack capacities.
I have included a link to the installation instructions for you to view.
view full answer... - Speed Rating of Thule Snow Chains
- With the Thule Tire chains like the Thule Self-Tensioning Tire Chains # TH04115097 installed we typically recommend a speed rating of between 30-35 miles per hour as the maximum speed.
Check out the review video I attached for this product and the snow chain FAQs also.
view full answer... - How Much Does The Curt Hitch C11576 Weigh?
- The Curt hitch # C11576 weighs about 26 lbs. This is actually much lighter than the other hitches made for a 2021 Camry. The draw tite brand hitch 36643 weighs about 35 lbs.
view full answer... - How Is Wheel Base Measured For The Swagman XC 2-Bike Rack Platform Style?
- The wheel base of the Swagman XC 2-Bike Rack Platform Style for 1-1/4" and 2" Trailer Hitches # S64650 is a maximum of 51-1/2" long. This is measured from the center of wheel loop to center of wheel loop so that you can measure the wheel base of your bike from the center of your front tire to the center of your rear tire and know if it will fit in this particular rack. The measurement from the ground to the bottom of the rack is the ground clearance, but we can't measure the ground clearance...
view full answer... - Dimensions of Sink Bowls for 25 Inch x 15 Inch Double Bowl Sink
- The Double Bowl Sink # 277-000601 measures 25 inches x 15 inches overall. Both sink bowls measures 10-3/4 inches x 13-1/8 inches. I've attached a diagram showing these measurements for you.
You are correct that this sink does not have cut-outs for the faucet or handles. For this sink, the faucet and handles would install through the countertop rather than the sink.
view full answer... - Curt Class I Trailer Hitch C11576 Fit on 2018 Toyota Camry
- Curt 1-1/4-inch Class I hitch # C11576 is a confirmed fit for the 2018 Toyota Camry and it also fits the hybrid version. In a separate email I have sent along the install instructions from Curt.
If you need a wiring harness you can use part # 118763 and for a ball mount part # 36071. If you are going to use the hitch for a bike rack or other hitch-mount accessory be sure to select a 1-1/4-inch Class I type, such as Thule bike rack # TH23JV and Curt cargo carrier # C18145. You will also...
view full answer... - Can a 2000 Toyota Camry Safely Carry a Wheelchair and the Carrier with the Curt # C12339
- Although the Curt Trailer Hitch Receiver # C12339 that you referenced has a Tongue Weight (TW) capacity of 350 lbs, from what I gathered by looking at the owner's manual for your 2000 Toyota Camry your vehicle may not be able to safely carry 350 lbs of TW.
On page 180 of the owner's manual is states that you cannot tow a trailer that weighs more than 2,000 lbs and then on page 181 is states that your trailer TW must be 9% - 11% of the loaded trailer weight. This means that your trailer...
view full answer... - Dimensions of the Thule Stainless T-Bolt # 853-5648
- To see all of the dimension of the Thule Replacement Stainless Steel T-bolt, # 853-5648, that you referenced check out the picture I attached.
The width of the square head is 3/4 inches, the length of the threaded portion is 22 mm and the threaded portion of the T-bolt has a 1.5 mm pitch and is 3/8 inches wide.
view full answer... - Can the 2017 Toyota Camry Hybrid Tow a Trailer
- I checked the owner's manual online for the 2017 Toyota Camry hybrid and all it says is that towing a trailer is not recommended. It doesn't say you can't but it also does not provide a towing capacity for the vehicle. So it is up to you on whether or not you want to go ahead and tow the trailer. I can definitely tell you the hitch, wiring and accessories you will need.
For a trailer hitch you can use # 36540. In addition to the hitch you will need a ball mount, # 36071. If the trailer...
view full answer... - Hitch Flex and Use of Support Straps When Hitch Bike Rack is Installed
- Trailer hitches have to be able to flex to avoid damage. The metals used in fabrication of a hitch like Draw-Tite # 36540 and Curt # C12107 are selected to allow for this. The mounting brackets on a hitch are not of the same metal formulation as the cross tube. A totally rigid hitch would be more likely to suffer damage. Some flex is okay.
Excess motion of a hitch-mounted accessory such as a bike rack is something else.
This is why Curt requires use of their stabilizing strap # 18050...
view full answer... - What Size Nut for Carriage Bolts of Curt Hitch C11576
- The size of the carriage bolt that comes with the Curt hitch # C11576 is M8x1.25 so that would be the matching nut size you would need.
view full answer... - Can Rhino Rack Heavy Duty Roof Rack Be Used For Carrying Ladder on 2007 Toyota Camry
- The Rhino Rack rack system can be used to carry ladders, as long as the weight of the ladder does not exceed the 165 lb capacity of the rack or the capacity of the vehicle roof, whichever is lower. You will need to consult your owners manual or Toyota for the capacity of the roof.
Rhino Rack does indeed highly recommend that any loads extending beyond the front or rear edge of the roof be secured to the front and rear bumper of the vehicle for the sake of safety. Tie downs that are designed...
view full answer... - What is the Distance from Center of the Hitch Pin Hole to the Closest Part of the Rack When Folded
- The Swagman XTC-2 Tilt part # S64671 has the same measurement for the pin hole to the closest point folded up or ready to use. That is right at 9.25". In my experience that will be more than enough to work on any vehicle while still clearing the rear bumper or hatch. The XTC-2 Tilt is a great rack with great reviews. It is built off of the extremely popular XTC-2 which is know for great cost effectiveness, durability and ease of use. They just added a tilting function to it to allow for...
view full answer...
Go To Results