Good news, I was able to go out and measure the outside diameter of the Lippert Drain Hose # LC359724.
The measurement I got was 3 inches for the outer diameter of the drain hose. The measurement for the molded end of the hose was 3-1/2 inches.
I have linked some images of the measurements for your convenience. view full answer...
The Trailer Valet RVR9 Remote-Controlled Trailer Dolly # TVRVR9 that you referenced will work great if you can keep the trailer weight under 9,000 lbs as that is it's weight capacity. The number of axles would not be an issue at all. view full answer...
As long as the total weight of the trailer and it's cargo are no more than 60,000-lbs then you can use the Curt Pintle Hook, Bolt-On, 60K # C48231 to connect the truck to the trailer. It sounds like you've got a 40,000-lbs capacity trailer, so this should work just fine.
I've linked a short review video of this pintle hitch for you to have a look at, as well. view full answer...
I went out to the warehouse and pulled the Lippert Waste Master RV Sewer Hose # LC359724 to measure the 90 degree end with the lever and handle. The overall length from the furthest point forward to the end of the handle is 8 inches.
The overall height is 10-1/4 inches. And it is approximately 4-3/4 inches thick. I have included a link to the manufacturer's demo video for you. view full answer...
The exact diameter of the little 9-toothed gear on the Replacement Motor for Kwikee Revolution Series Electric RV Steps # LC380073 is 15/16 of an inch. I went ahead and included a diagram of the dimension for your convenience. view full answer...
The Andersen Ultimate Connection 5th Wheel Trailer Hitch System with Adapter # AM3200 is 24 inches long by 24 inches wide and will sit 12.5 inches above the bed rails. When you add the hitch ball, it will be 15.75 inches, 16.875 inches, or 18 inches from the base to the top of the hitch ball. I've attached a photo of the manufacturer's dimensions to assist. view full answer...
The Enhanced-Height Lens, # 47-84-712, is 1-1/8 inches deep. I have included a picture showing this and other measurements for you. view full answer...
The length of the PTC Custom Fit Cabin Air Filter # 3513033 is 13.5 inches, the width is 6.6 inches, and the height is 1.18 inches.
This fits the following vehicles:
2000 - 2003 Ford Escort
2000 - 2009 Ford Focus
2010 - 2013 Ford Transit Connect view full answer...
The distance between the bolt holes on the Curt Trailer Hitch Receiver # 14080 is 39-1/4" center-to-center. I have attached a photo to demonstrate this. Please note that this trailer hitch fits the following:
2002 - 2002 Chevrolet Avalanche
2002 - 2002 Cadillac Escalade
2002 - 2002 Cadillac Escalade EXT
2001 - 2002 Chevrolet Suburban
2001 - 2002 Chevrolet Tahoe
2001 - 2002 GMC Yukon
2000 - 2002 GMC Yukon XL
2000 - 2000 Chevrolet Tahoe excluding Limited and Z71
2000 - 2000 Chevrolet Suburban... view full answer...
Yes, we do have a way to plug in a Redarc Brake Controller like item # RED24FR or item # RED44FR to the factory port on your motorhome's Freightliner XC Chassis. Since your motorhome's older you will need to use two separate connectors. The Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers item # 3027-P and the Redarc Tow-Pro Wiring Adapter for Tekonsha Brake Controller Harness item # 331-TPH-017. These two harnesses combined will give you a plug and play installation. view full answer...
The effective lumens rating for the Optronics LED Thinline Interior Lights, # ILL71CB, is 342 lumens. It is difficult to compare the lumens output of this LED light strip to a 2 tube fluorescent light without knowing the length and wattage of the fluorescent bulbs.
After doing some research, it seems that many 16 inch fluorescent bulbs are 16-watts and these bulbs have a lumens output of 1000. With this information, we could say that a 2 bulb fluorescent light that has two 16 inch, 16-watt... view full answer...
The dimensions of the Roadmaster Reflex Steering Stabilizer for Class A Motor Homes # RM-RSSA are
26 1/2" from eye to eye. The eyelets have a measurement of 1/2".
Since we do not carry the Safe T Plus products, I'm really not able to comment or compare their products to the Roadmaster RSSA. I would suggest reading the customer reviews on the Roadmaster RSSA. view full answer...
I spoke to my contact at Surco and she informed me that from the very top to the very bottom the Surco Ladder part # SP501L measures 97 inches.
The distance from the portion that attaches to the roof of the RV to the ladder is 17 inches. view full answer...
Per Buyers Products' website, this hitch plate # 3371809061A measures 17.2" tall by 62" long at the bottom and 34-1/4" long at the top (measured from inside the mounting bars) and is constructed with 1/2" thick steel. I've attached a diagram as well. view full answer...
I went ahead and called Gen-Y Hitch and they let me know that the Sway Control Plate for Gen-Y Glyder or Rebel Ball Mounts # GY33YR is approximately 3/8" thick.
I've attached a dimensional diagram for you to check out as well. view full answer...
I went to the warehouse and pulled one of the support pegs, part # 8535. I took some measurements of the bracket used to mount the support pegs and they are shown in the attached photo.
The bracket outside dimensions are 2-1/4 inches x 1-1/4 inch. The distance from the mounting holes center-to-center are 13/16 inches and 1-3/4 inches. view full answer...