Expert Answers about Hyundai

• Reusing Hardware From MaxxAir II Vent Covers on FanMate Vent Covers
• The MaxxAir FanMate RV and Trailer Roof Vent Cover # MA00-955001 will not connect to the Installation Hardware for MaxxAir II RV and Trailer Roof Vent Cover. This is due to the covers being different sizes and therefore the mounts in the FanMate are not as long as the MaxxAir II mounts. The FanMate is designed to clip on to the MaxxAir MaxxFan's that have the quick attach mounting tabs already included on their fans produced since 2015. So if you have those vents then you can utilize...
  view full answer...


• Brake Controller That Won't Require Actuator Adapter Module For Hydraulic Disc Trailer Brakes
• The Tekonsha Prodigy P3 Trailer Brake Controller # 90195 will work on up to 4 braking axle with electric brakes or electric over hydraulic. To install this on your 1999 Ford F-350 you will need to wire the controller to the bare ford harness or cut off the Ford connector to connect the Tekonsha pigtail. You will not require the HydraStar Electric Over Hydraulic Actuator Adapter Module # HBA-CAM that is required for most trucks with a electric brake only, brake controller.
  view full answer...


• Spacers For Air Lift LoadLifter 7500 XL Air Springs on Lifted 2021 Chevy Silverado 2500
• Yes, spacers are needed for your lifted 2021 Chevy Silverado 2500 for use with the Air Lift LoadLifter 7500 XL Air Helper Springs # AL57541. You can choose the right ones for your application: - 2 Inch Lift: Air Lift Spring Spacers # AL52420 - 4 Inch Lift: Air Lift Spring Spacers # AL52440 - 6 Inch Lift: Air Lift Spring Spacers # AL52460 If you're in between those heights, go with the lesser height as the air springs stretch. Along with the spacers, to avoid any leaks when installing...
  view full answer...


• Gen-Y Fifth Wheel to Gooseneck Adapter that Fits 2023 Sabre 38DBQ
• Based on the Lippert 1621 style pin box we know your 2023 Sabre 38DBQ has and the GVWR I found online for it the correct fifth wheel to gooseneck adapter you would want is the Gen-Y part # GY58GR.
  view full answer...


• Recommended Hitch for a 2024 Toyota Grand Highlander
• Yes, it does. The Curt Hitch item # C26VV is the only hitch currently available that fits a 2024 Toyota Grand Highlander. This hitch is custom fit and bolts to your Toyota with included hardware. This is a class III hitch with a 2" receiver. It has a 5,000 lbs towing capacity and a 500 lbs maximum tongue weight. I really like this hitch because the entire crosstube mounts behind the rear bumper. This leaves only the 2" receiver exposed which not only looks better but helps with ground...
  view full answer...


• Hitch Pin Holes on Draw-Tite Hitch Do Not Line Up
• The Draw-Tite hitch has one set of holes for your hitch pin to go through. There is an extra hole on one side in case you decide to use the optional Tow Ready # 63201 J-pin lock set and anti-rattle device instead of a standard hitch pin. While I am not right there to see the issue, I suppose it is also possible that your bike rack has a 1-1/4" square shaft that you are trying to put in a 2" receiver. Most 1-1/4" bike racks come with an adapter for 2" receivers. If yours does not you could...
  view full answer...


• Recommended Dual Ball Mount for Using a Bike Rack While Flat Towing a Vehicle
• You are on the right track but you need to use the Gen-Y Adjustable 2-Ball Mount w/ Stacked Receivers item # 325-GH-315 instead. This ball mount is rated to be used with a flat towing set up and a bike rack. The Gen-Y Phantom Hitch Ball Mount item # GY27VR can only be used with Gen-Y accessories. It's not built strong enough to support a flat towed vehicle and a bike rack. If you don't have any intention of using the ball mount to tow a trailer, then I recommend just getting the Replacement...
  view full answer...


• Can NOCO GEN On-Board Battery Charger Negative Cables Be Connected to Same Terminal
• Hey Danny, thanks for reaching out! It sounds like your battery bank is setup in a parallel series configuration (see attached) so you'll need to connect each negative wire to the negative post on each battery for the 3-Bank NOCO GEN On-Board Battery Charger # NOC94FR to avoid errors with the operation of this charger. I confirmed this with my contact at NOCO, and it is the same case for all other chargers that connect to individual batteries in a bank. If you have a different battery...
  view full answer...


• Gooseneck Hitch for 2012 Ram 2500 that Can Use Offset Ball
• Hey John, you'd have to go with an all new gooseneck hitch since Draw Tite doesn't have an offset ball for that hitch. You'd need the B and W Gooseneck part # BWGNRK1308 for if you have a gas engine or part # BWGNRK1313 if its a diesel. Then you could use the offset ball part # BWGNXA4085 which would give you 4 inches of offset.
  view full answer...


• Can Roadactive Kit be Installed at Same Time as Air Bag Kit on 2023 Ford F-150
• Hey Josh, it's pretty hard to verify fit of two suspension enhancement kits on a vehicle as they weren't intended to be stacked like that. If you aren't happy with the air bag kit I would recommend removing it and installing the RAS kit part # RAS3611-YHD as this will give you the support you are looking for without negatively affecting ride quality. The RAS kits are known to actually improve ride quality loaded and unloaded as well as improve handling.
  view full answer...


• Availability of Amber Porch Light for RV
• Hey Phillip, so we have amber porch lights available but we don't have any that are 12 inches long so we wouldn't have any replacement lenses that would work for you. Best option would be a new porch light with an amber lens like the part # RVPLL13AB or you can check out the link I attached to this page that has all of the amber lights we do carry.
  view full answer...


• Could Hitch from Chrysler Town and Country Fit 2008 Honda Pilot
• Hey Mary, so hitch fits are really specific so unfortunately it isn't possible to take a hitch from a Chrysler and fit it to your 2008 Honda Pilot. You would need a hitch that fits your Pilot like the part # e98851.
  view full answer...


• Is There A Swing-Away Hitch Adapter That Can Haul E-Bikes And A Boat
• Hey Kevin, Swing-away hitch adapters can't be used to tow and aren't designed to be used with other hitch adapters so you wouldn't be able to tow your boat and haul a bike rack at the same time. Swing-away adapters will also reduce the overall capacity of your trailer hitch by 50% as well so it would likely make you overloaded hauling e-bikes. If your goal is to be able to haul your bikes and trailer together then yo-u can used a stacked receiver like Gen-Y's # 325-GH-315. This would...
  view full answer...


• What is the Best Sealant for Trailer and RV Roof
• I strongly recommend the TremPro 644 Silicone Sealant # 0160297. I used this sealant on my trailer when I replaced a roof vent about 4 years ago and it is still going strong. This sealant does a great job at holding up to dramatic temperature changes without shrinking, drying up or cracking. This sealant works great on all types of trailer materials including metal, wood, and plastic.
  view full answer...


• Could Progressive Dynamics Replacement Converter # PD4060CSV Fit 2016 R-Pod 180
• Hey Tony, so we don't know for sure what converter you have in your 2016 R-Pod but if it's a Progressive Dynamics 4000 kit part # PD4060K then yes the replacement converter part # PD4060CSV would be what you would need.
  view full answer...


• Which Adapter for 2019 GMC Sierra Towing RV with Furrion Vision S Camera Kit
• Hey Don, actually you can use either but if was me I would go with the Voyager adapter part # VGR64VR since its more of a permanent install and wouldn't require you to have to remember the adapter everytime you plan to tow.
  view full answer...


• Recommended High Low Adapter to Allow Tailgate to Open While Towing Micro Minnie Winnie
• Dan, I would need to know how much room you need to be able to open the tailgate with the trailer attached but you could theoretically use the Roadmaster High-Low Adapter for Tow Bars # RM-048-8 which would lower your receiver 8" likely giving you the clearance needed to drop the tailgate.
  view full answer...


• Recommended Ladder Rack For A 2014 Toyota Tundra With Deck Rail System
• Hi Maurice, Thule offers the TracRac SR which mounts in the stake pockets so that you still have the cantilever and don't have to remove your deck rail system. If your Tundra doesn't have the stake pockets then the installation will require drilling into the bedrails. The design of this ladder rack will also allow you to install tonneau cover as long as it sits inside the bedrails and doesn't overlap the top of the bedrails. 6-1/2' bed # TH43002XT-610EX 8' bed # TH43002XT-011EX If...
  view full answer...


• Wheel Stud Length for the Dexter Trailer hub and Drum Assembly
• Actually Gordon, the wheel studs used on the Dexter Trailer Hub and Drum Assembly for Heavy-Duty 15K Axles # DX78QR are Replacement Dexter 4-3/4" x 1-1/2"-20 Press-In Wheel Stud # DX97XR which are 1 1/2" long.
  view full answer...


• Can Yakima EasyTop Universal Fit Roof Rack Be Used to Haul Lumber
• Hey Michael, great question! As long as you've got everything secured properly I don't see any reason why you can't use the Yakima EasyTop Universal Fit Roof Rack # Y07418 to haul some lumber - I like the way you're thinking outside the box!
  view full answer...