I spoke with my contact at Camco and he informed me that the Backflow Preventer part # CAM23303 that you referenced should be installed after the water pump. view full answer...
We have a solution that matches what you are looking for, but the Curt cargo carrier part # C18151 that you referenced does not have a hitch opening at the front of it for a bike rack to attach to.
Instead you'd want the Hollywood Racks Cargo Carrier Bike Rack # HR1400Z-85 which comes with both a carrier and a bike rack. This can be used in three configurations. Bike rack only, cargo carrier only, and bike and cargo carrier. view full answer...
As you already have the 4-way flat connectors on your two Saturn Vue's you will only need a 7-Way RV Upgrade Kit for Trailer Brake Controller Installation # ETBC7L for each vehicle. This will provide you with the 7-way that connects to your 4-way and has the wiring for running power to the 7-way charge line.
The Curt Echo Wireless Trailer Brake Controller # C51180 works differently from other brake controllers. It is powered by the charge line on the 7-way circuit. It uses the input from... view full answer...
We do not have a tail light kit specifically for the Curt hitch mounted Cargo Carrier, item # C18100.
A better solution may be the Pro Series 24x60 Railed Cargo Carrier for 2 inch Trailer Hitches, item # 63153 , along with the Light Kit for Rola Railed Cargo Carriers, item # 20174 or the LED version, part # 98174LED. The lights recess into this carrier and are well protected by the carriers railing. view full answer...
Whenever you hear conflicting stories about flat towing a vehicle it is always best to turn to the owner's manual as the manufacturer (in your case GM) will have the final say. I looked up an online version of the owner's manual for your 2008 Saturn Vue and it says on page 4-42 that both FWD and AWD can be flat towed. I recommend checking your copy of the owner's manual to verify this (it will be under Recreational or Dinghy Towing).
For a complete flat towing setup you will need a base... view full answer...
The Gray WeatherTech Cargo Liner # WT42221 is a custom fit floor mat and was designed to fit all models of the Saturn Vue from 2002 to 2007.
The photo is intended to give you an idea of the color, but not the shape. The shape will be perfect for your cargo area. view full answer...
If you have a 2007 Saturn Vue, depending on which brake controller you're trying to install, you will need an adapter to be hardwired into your vehicle. This is because the Vue does not have a factory plug for a brake controller to plug into.
For example, Curt controllers need adapter # C51515 for your vehicle. Tekonsha and Draw-Tite Controllers need adapter # 20127.
If you let me know which brake controller you're trying to install, I can help you further.
Also, keep in mind that in... view full answer...
There are a couple different reasons why trunk mounted bike racks are not recommended for your 2008 Saturn Vue. Most second generation Saturn Vues (2008 to 2010) have a small plastic trim piece or a plastic spoiler at the top of the rear hatch. The upper straps of trunk mounted bike racks attach to the top edge of the rear hatch and this plastic trim piece or spoiler is not designed to support the weight of the bike rack and bikes. The plastic could deform or break from the pressure.
Another... view full answer...
Yes, I checked with Roadmaster to confirm that the Roadmaster Tail Light Wiring Kit # RM-155 that you referenced would work on your 2007 Saturn Vue and it does.
I attached installation instructions and an install video for you to check out also. view full answer...
They are basically a safety chain setup for the base plate kit. They are designed to attach to the frame of the vehicle and the base plate kit.
This is actually a common issue that our installers also deal with on many different vehicles. It is not spelled out in the instructions but since these base plates do not have an attachment point especially for the short cables included with the base plates you will have to loop the cables around the base plate assembly and around the frame somewhere... view full answer...
The Dexstar Vintage Steel Wheel is a 5-1/2 inch wide wheel and will accept 14-inch bias ply trailer tires, in ST205/75D14 and ST215/75D14.
In the ST205/75D14 tire size we have the, # AM1ST86, load range C.
In the ST215/75D14 tire size there is one load range C tire available in bias ply, # AM1ST90.
I provided a link to our Trailer Tire Sizing chart for you to review also. In the Chart you can compare all of the tire sizes, diameters, load ranges and appropriate rim widths, to match your... view full answer...
To test the tail light wires on your 2005 Saturn Vue using a multimeter you will first set the meter to read voltage. There should be several settings to test voltage but you want the lowest setting. Then you can either pierce the wires to test them or unplug the tail light and test the connector pins (if equipped).
Have someone sit in the car and run through the light functions while you test the wires. The functions that power on should be near 12 volts and the others should not show... view full answer...
The parts you need to tow with your Saturn Vue include a trailer hitch, wiring, and a ball mount kit. If the year of your Saturn Vue is a 2006 like what you were looking at then I recommend the following:
etrailer Class III Trailer Hitch - # e98865
T-One Wiring Harness - # 118418
Ball Mount Kit - # EBMK4
If you have a different year model just let me know what that is and I can make some different recommendations if I need to. view full answer...
Yes, the Blue Ox base plate kit part # BX3321 that you referenced is compatible with the Blue Ox Aventa II BX7335 that you mentioned. view full answer...
I double checked with the Thule Fit Guides and the Passage, part # TH910XT, will fit your 2005 Saturn Vue. Below, I have added a link to a video demo of how the rack works. Thule uses a quick-adjust dial to quickly set the rack at the proper angle for your vehicle. For the 2005 Vue, your dial setting is 11. view full answer...
I am sorry, but the 407-1 will not fit your 2005 Saturn Vue. The base plate for your vehicle is the 3111-1, the Roadmaster XL Base Plate Kit.
If your tow bar is the Roadmaster Tracker, which has the entry-level towing capacity of 5,000 lbs, then the base plate I just recommended, the 3111-1, is compatible with it. You will need the optional set of quick-disconnects, product RM-201, to use with the base plate and the tow bar. The quick-disconnects are defined as optional on our website,... view full answer...
The Camco RV Portable Propane Campfire # CAM58041 has a built-in regulator so it can connect directly to your RV's high-pressure propane feed. My contact at CAMCO confirmed this is the preferred installation method.
It comes with an 8 foot hose for you to use to connect to your RV.
The part # CAM59143 does come with fittings that would allow it to be compatible with the fire pit as well. view full answer...
You do need a lighting solution installed on your 2006 Saturn Vue to allow the taillights of it to be controlled by your motorhome when it's being flat towed. For that we have the # RM-152-98146-7 which wires into your taillight wiring and allows the motorhome to control them and comes with all of the wiring, diodes, and connectors needed. view full answer...
Yes, we do have mounting hardware available for Curt # 13591. The part number for the Replacement Hardware Kit is # RHK. Enter RHK in the search box and then you will need to enter 13591 for the Hitch Item Number and Curt for the Manufacturer. view full answer...
Go To Results