The Stromberg Carlson 100 Series 5th Wheel Tailgate # VGT-70-100 is the correct model for your 2016 Toyota Tundra. This measures 63-3/4" left to right at the top and 64" across at the bottom. The height on the side is 25-1/4" and it is approximately 14" tall in the middle. view full answer...
The pins of the Hopkins 7-way part # HM11143395 that you referenced are standard in size and would work with all standard 7-way plugs. I could see a narrower pin setup still working too since it's all about making contact but there's no reason to be concerned with the pin width of the # HM11143395. view full answer...
I had our warehouse workers pull WeatherTech Under Seat Truck Storage Box - Black # WT56HR to get that measurement for you. At the deepest point it is 6" and at the lowest point it is 4". This is confirmed to fit your 2014 Toyota Tundra view full answer...
I confirmed with Curt that the Replacement Head for Curt MV Weight Distribution Systems # C17075, has a Gross Trailer Weight (GTW) capacity of 14,000 lbs and Tongue Weight (TW) capacity of 1,400 lbs. view full answer...
I took a look at the owner's manual for a 2012 Toyota Tundra and its ratings for towing a fifth wheel trailer are based on the GCWR (Gross Combination Weight Rating), which is the weight of your fully loaded '12 Tundra PLUS the weight of a fully loaded trailer. Put simply, your towing capacity will be your GCWR minus your GVWR, which I'll detail for you with an example, but the issue is that for a '12 Tundra, the GCWR is going to depend on a couple factors.
The GCWR (maximum capacity your... view full answer...
The CargoGlide 2200XL Sliding Tray for Trucks # CG2200XL-6348 has outside dimensions of the are 63 inches long and 49.25 inches wide. The inside deck surface is 62 inches long and 48 inches wide and the total deck height is 8 inches. The total weight then is 360 lbs. view full answer...
The weight capacity of the Darby Turbo-Rack Universal Single-Bar Roof Rack # DTA968 is determined by the roof capacity of the vehicle you are going to be installing it on. You will need to refer to your owner's manual for the capacity.
It will work well with the Erickson Big Bed Junior Load Extender # EM07605. view full answer...
There are two sets of bolts required to mount the rails # RP58058 to your vehicle. There are 10 1/2"-13x2" GR5 carriage bolts, and 8 that are 1/2"-13x1-13/8" ribbed neck bolts. You can purchase these bolts at Reese Universal Installation Kit for 5th Wheel Trailer Hitches (No Base Rails) # RP30439.
This kit includes all the hardware needed to install your rails, as well as, universal mounting brackets that will fit most vehicles. view full answer...
Yes, it will! The RetraxPRO MX Hard Tonneau Cover item # RT80841 leaves the stake pockets open so it is compatible with the Thule TracRac SR Sliding Truck Bed Ladder Rack item # TH97RV. Both of these systems are confirmed to fit your 2016 Toyota Tundra with a 5-1/2' bed and the deck rail system.
Please note that any other Thule TracRac Ladder Rack that mounts to the inside of your truck bed rails will not be compatible with the RetraxPRO item # RT80841. You have to use a ladder rack that... view full answer...
From the top of the bed rails to the top of the uprights of the Adarac Aluminum Ladder Rack # A4001665 measures 66 inches. Since this fits various trucks which will have varying cab heights I can't get you exactly how much taller than the cab it will be but you can measure 66 inches above your bed rails and you'll know where it will be. view full answer...
The 6,000 lbs weight capacity listed for the Timbren Active Off-Road Bumpstops # TABSTORSEQ is the vertical load limit of the bumpstops. When towing a trailer, the trailer weight is distributed between the trailer axle and the tow vehicle. The weight that is transferred to the tow vehicle is referred to as "tongue weight" and is usually about 10% - 15% of the gross trailer weight. You will never actually have the full 7,500 lbs of your trailer weight being transferred to your vehicle and... view full answer...
The CTM4000 mirrors for Toyota Sequoia and Tundra measure approximately 5-3/4 inches across the bottom, and 4-1/2 inches across the top. view full answer...
I spoke with my contact at Bulldog and the Powered-Drive Trailer Jack, # BD500187, measures 20-1/2 inches from the mounting bracket to the top of the jack. I have included a picture showing this measurement for you. view full answer...
According to pages 167-169 of the online owner's manual for your 2017 Toyota Tundra Crewmax 5.7L V8 the most trailer weight this truck can tow is 10,100-lbs. You will want to refer to your printed manual too since this maximum capacity depends on the specific engine and drivetrain and whether or not you have the optional towing package. Many versions have lower capacities. You can also check with your local dealership using the truck's VIN.
For 5th wheel towing in this truck your 5-1/2-foot... view full answer...
Then length of the base rails in the TracRac SR Sliding Truck Bed Ladder Rack # TH43001XT-501 that you referenced is 77-1/2 inches. view full answer...
The highest capacity trailer hitch we offer for your 2000 Toyota Tundra is the Draw Tite part # 37130 which has a 7,000 lb towing capacity. The price is available at the product link below. view full answer...
The Ultra-Fab leveling blocks, # UF48-979051, have a 30,000 pound capacity. These blocks are rigid and could potentially flex some if torqued enough. A co-worker has blocks similar to these and he has not experienced any cracking, even in cold weather, but he says what will happen over time is the tops will start to get smooshed. Otherwise they will be a durable item. view full answer...