I have linked an article that describes the location of the BCM (Body Control Module). If you cannot locate the cold-side wire at the brake pedal switch using a tester such as # PTW2993 you can instead use the wire on the BCM that activates the center high-mount stop light (CHMSL) to provide the activation signal for the Voyager. You will need to test the wires at the BCM to find the one that carries voltage only when the brake pedal is pressed (often this is a white wire). Please refer... view full answer...
I spoke to my contact at Dometic and they told me that the Fan-Tastic Vent Roof Vent w/ 12V Fan and Remote - Powered Lift - 14-1/4" x 14-1/4" # FV807350 does reopen once the sensor dries. view full answer...
In regards to the etrailer Trailer Hitch Receiver part # e98865 on your 2007 Pontiac Torrent, the first issue you are having with the weld nuts inside the bumper beam is most likely due to them being stripped. This would have most likely been caused by the threads not being cleaned properly before the bolt was threaded in. Unfortunately, the fix for this will be to either drill and tap these nuts with the next size up drill bit/tap or to remove the weld nut and then use a carriage bolt... view full answer...
Yes! The 4-way wiring harness is designed to send a signal to the brake lights and the turn signals. The green wire is for the right turn, the yellow will control the left turn and the brown wire will be the brake lights. For the wiring harness to function properly it will need to be grounded, that is what the white wire is for. This Curt T-Connector # C56012 wiring harness will directly plug into the plug located in your 2007 Pontiac Torrent and provide you with a 4-way plug for your... view full answer...