I recommend the Kuat Pivot Swing Away Hitch Extender part # PVP20B. The Kuat Pivot Swing Away will allow you to attach a cargo carrier or bike rack to a 2" trailer hitch receiver tube opening and then pivot that accessory out 90 degrees to clear the rear doors on your van. The swing arm comes with a locking anti-rattle threaded hitch pin however, you would also need a locking hitch pin to secure your bike to the swing arm. view full answer...
According to Curt, on some vehicles with air compressors, the plugs will not be accessible through the storage compartment. You would need to pull back the interior trim panels to access the connectors. So the Curt T-Connector Vehicle Wiring Harness with 4 Pole Trailer Connector, # C55355, is the correct harness for your 2001 Pontiac Montana. I have included a link to the installation instructions below.
I do not recommend splicing the brake light wire into the turn signal wire as it would... view full answer...
Yes, the Thule Gateway Pro 3 Bike Rack, # TH78VR, will work on your 1999 Pontiac Montana. It comes with all the hardware you will need to attach to your vehicle.
The bike rack has a total weight capacity of 105 lbs. or 35 lbs. per bike.
If you will be transporting any womans or kids bikes that do not have the center horizontal bar, we have the Thule Bike Adapter Bar, # TH982XT. It clips on to the seat post and the handlebar post to give you a horizontal bar for carrying the bike level... view full answer...
Yes, the Curt Class III Trailer Hitch, # 13344, will fit your 2000 Pontiac Montana with a short wheelbase. This hitch would actually be my recommendation for you. I usually prefer Curt trailer hitches because I know they like to be a little liberal with their powder coating and in this case, it has the highest weight capacities of any hitch for your van so it has plenty of built-in safety margin.
All of the wiring harnesses for your vehicle are basically the same thing, but built by different... view full answer...
You can use a brake controller on a 2006 Pontiac Montana SV6 AWD. The 2006 model was renamed the Montana SV6.
To install a brake controller on your vehicle you will need a 4-way at the rear of the vehicle and then use the Brake Controller 7 & 4 Way Installation Kit, # ETBC7, along with the brake controller.
To install a 4-way trailer connector at the the rear of your vehicle you will use the Tow Ready T-One Wiring Harness, # 118396. This harness will plug into the back of your taillights... view full answer...
2 inch or 2-5/16 inch diameter balls are pretty standard sized balls, it is not surprising that the coupler on the 1997 Coleman camper accepts either one of those sizes.
For a 2 inch ball I would recommend a Hitch Ball with 2 inch Diameter and Medium Shank, part # 19247.
If you need a ball mount as well I would recommend a Ball Mount 2-3/4 inch Rise or 4 inch Drop, part # 2753. view full answer...
The Hopkins Backup Alert would replace a 3156 bulb. I checked an online copy of the 2005 Pontiac Montana, and found that the reverse light bulb on your van is a 3156.
The # HM20101VA will fit your Montana. view full answer...
Go To Results