The Edge EZ for Dodge Cummins 5.9L, 24V # EZD1000A does not require an OBD-II port to install, as you can see in the linked instructions; you will only need to plug the EZ connectors into the ECM Data Link connection and MAP sensor. This programmer is designed to be used with a 5.9L Cummins 24V engine like you have so it will work for you. view full answer...
We carry replacement entry door hinges for your 1999 Fleetwood Discovery like with the # LC95VR for black which is a controlled motion hinge and part # LC22NJ for white. Controlled motion hinges hold the door in any position you leave it in so that it does slam in either direction. view full answer...
There are a couple of things you will need in order to add a 7-way trailer connector to your 2002 Freightliner, starting with a 4-way you will need to hardwire in, the ZCI Circuit Protected Vehicle Wiring Harness with Installation Kit # 119250KIT.
This does come with a converter which allows it to be used with your 3-wire system so you're good to go there. The other part you will need to complete your set up is the Universal Installation Kit for Trailer Brake Controller - 7-Way RV and... view full answer...
The lug nut cover part # WMRMT9061 is made from stainless steel and could work if you have a 20 mm lug nut on your wheels like the part # WMRMT9063 that this was designed to fit. We do not have anything made from tin though. view full answer...
For a vehicle like yours that has separate turn signals from stoplights you'd need a trailer wiring setup that has a converter box like the part # 119250KIT which was designed for this type of application. view full answer...
The small amount of wind that's on the very top of an RV like your Sprinter van might surprise you due to how it deflects and goes over most of the top of it instead of hitting it straight on. So what that means is that there wouldn't be much wind at all on the Furrion Chill part # F15PA12SASA-W and you'd be totally fine to do 75 mph. We've sold quite a few AC units over the years and not once have we had an issue with wind hurting one. view full answer...
The Draw-Tite Ultra Frame Service Body Trailer Hitch Cross Tube # 41990 will definitely be a good option for your 1998 Utilimaster step van, as long as the frame is not longer than about 44" as you will need some cross tube for the brackets to be welded on.
As to the brackets, the correct ones will depend on how low the bumper sits from where the hitch will be mounted to the frame. We have these brackets in a 7" drop ( # 4907) as well as a 16" of drop ( # 4916) if needed. view full answer...
Go To Results