From what I could find a special fitting is not needed when installing a transmission cooler on a 2000 Chrysler LHS. The Insta-Dapt fitting, # D13004, that comes with the coolers we sell should be all you need.
Fitting # D13034 would fit if the lines on the vehicle take a 9/16-24. But that can be difficult to determine. A Chrysler dealer may have this information if you speak to a tech in the service department. view full answer...
I am sorry but there are no replacement control panels or remotes available for the Fantastic Vent Model 5250. That model of vent is obsolete and they aren't making replacement parts specifically for it anymore. You can either try to source the parts through used vendors or you can replace your fan with the MaxxFan Plus Roof Vent w/ 12V Fan, Thermostat, and Remote - Powered Lift - 10 Speed - Smoke item # MA00-04500K. I have linked a review video below. view full answer...
We offer a Class II hitch, part number 36170, available for your vehicle. The hitch is rated to tow 3,500 lbs and has a tongue weight capacity of 300 lbs. I would recommend checking the gross weight of the trailer, with it fully loaded to find your tongue weight. If your weight is under 300 lbs, then this hitch will accommodate your trailer application. You will also need the ballmount, part # 36063 and the 2 inch Ball, part # 19258, as well as a pin and clip, part # PC2 or a hitch lock,... view full answer...
It looks like a 1996 Chysler LHS and a 1996 Chrysler Vision TSI share the same frame design at the rear and this Draw-Tite Hitch, part # 36170, would install onto either.
Without knowing the brand of hitch that is on the Chrysler Vision it would be difficult to say for certain that the hitch from it would work on your LHS.
It seems like there is a good chance that it would, but I can not say for certain.
If it did fit it, you would also want to consider the the condition of the used... view full answer...
The weight capacity for the Hollywood Racks TRS 2-Bike Platform Rack # HR3000 that you referenced is 50 lbs per bike. The capacity is more than just for the overall capacity of the rack though. Each of the rails is only rated for 50 lbs so if you need more capacity this rack would not work.
A similar rack that would work is the Saris SuperClamp EX part # SA4025F, which has a capacity of 60 lbs per bike. This rack is also much lighter at 35 lbs compared to 57 lbs with the TRS. This would... view full answer...
Go To Results